Do one think .. Remove each injector socket and try to crank the engine each time, one injector might be short and droping injection voltage, so this will locate short injector ..... And also check resistance of injectors pin to body ground
My point is to disconnect the # 1 injection cube and try to start the car. if the engine does not start, connect the cube back to the same place and do the same with the next injection number 2? Right?
Its not dangerous but scan and check DTC, if there is no DTC then could be low battery charging or alternator may be faulty ...... Car might not start sometimes
My duster 2013, when it is stopped for more than 30 mins, after than when we on the key, engine light does not glow, later i have to remove and plug back the yellow 40Amp relay, and little adjustment, it starts. It is happening continously. Any solution?
@@devautoelectronics i replaced relay, still same thing. Showed to mechanic, he says may be wiring needed to be changed. I know it is not loose, else while driving it would have lost contact. Because once car is started it can go running for whole day no issue when engine is on
Sir duster me ek aur fult at hai injector ko current nahi ata kya fult hosakta hai scan karne se koi cult code nahi ata
Ho sakta hai, fuel pressure sahi hai to injector soket mein bulb lagake crank karo samjega
Sir band gadi me injector ka plug nikalo tab open circuit nahi ata
@@shaiknaveedalam7208 injector soket nikalke statrt karo 2 3 bar tabi code ayega
Nahi ata ye duster me fult hai apka number do
Sir apka number do please
hi i can't start the dacia duster DTC P062B fuel injector internal control control module. can you tell where to look for the problem?
This is basically problem in the ECU, please check all the 12 volt supply to ECU, otherwise the solution is repair or replacement of ECU
Do one think .. Remove each injector socket and try to crank the engine each time, one injector might be short and droping injection voltage, so this will locate short injector ..... And also check resistance of injectors pin to body ground
My point is to disconnect the # 1 injection cube and try to start the car. if the engine does not start, connect the cube back to the same place and do the same with the next injection number 2? Right?
@@sebastiansomski513 yes👍
can we get in touch on messenger?
Hlo sir Red light show stop 🛑 is that dangerous??
Its not dangerous but scan and check DTC, if there is no DTC then could be low battery charging or alternator may be faulty ...... Car might not start sometimes
How can I scanned and what is DTC?
If battery low no dtc will trigger, scan on scan tool buy from amazon " ELM327 OBD adopter"
@@devautoelectronics thank you..
in my duster only red light is blinking in speed engnine light is only on so what is the problem can you tell me
Scaning is required first to know the idea of fault ..... Scan and tell me DTC
Good
Superb Video.
Battery aged and salfeted slow charge is ok but in cold or rainy season problem 😫
This battery suddenly died and owner did not believe, so I go through the through process
Hai my terrano engine stop light on while driving after few km
Please scan first and check DTC codes
Hello sir can I ask questions
Yes please
Why my duster shown open door signal
@@devautoelectronics Red color one
@@haborjerangjerang4052 one of your door switch is open not making contact, so its showing door open
@@devautoelectronics Thankyou it's mean a lot...
Engine stop signal ka kiya matlab
Engine mein problem hai, don't start
@@devautoelectronics arey bhai mai to drive krke gum RHA hoon. Please exactly batana engine mai exactly Kiya problem hai
@@Johnvlogs9 scan Karo Tabbi malum padega
Sir ji chek engine light mi stop light aara pls batao ky karna
Battery low to nahi hai na, battery check Karo Pehla bad mein scan karo
Battery sahi hai sir
Car startin hura
Stop light aara
Scanning kiya tu flat p0002 or p0094 or p0089 aary code
My duster 2013, when it is stopped for more than 30 mins, after than when we on the key, engine light does not glow, later i have to remove and plug back the yellow 40Amp relay, and little adjustment, it starts. It is happening continously.
Any solution?
Try replacing relay or it might be problem near ecm wiring connector
@@devautoelectronics i replaced relay, still same thing. Showed to mechanic, he says may be wiring needed to be changed.
I know it is not loose, else while driving it would have lost contact. Because once car is started it can go running for whole day no issue when engine is on
@@Nilesharma650 right, else that could be the ecm
Brother?