It's not that hard to disassemble, but to put it back in... Hardest part is the spring. You have to twist it a good couple of times, so that it fits way down into plastic cover, while holding it's outer hooked end in a cut out in the cover. I did it by holding it in a vise with little nut pressing spring's hooked end and then twisted the spring with small pliers, while trying to push it down with a screwdriver. Then, you have to twist it even more with using that can carrier - you put inner hooked end of a spring in its cut out and then turn it counter-clockwise a good half turn, untill you put its protruding "leg: after a matching protruding "stopper" in a cover. Only then you mount everything in reverse. Took me half a day, good luck xD.
I used a big slot screwdriver to put the spring back into place (just small turn an pushing it inside). After hours of trying this worked for me fine in a few seconds. no guarantee that you will break something.
Привіт, у мене такий самий перемикач, перестав крутитися, я розібрав його там все було занедбано , а ось зібрати назад проблематично . Що саме ти мав на увазі в кінці відео махаючи пальцем, чого саме слід не робити? незрозумів.
![แข่งเพิ่มน้ำหนักใน 24 ชั่วโมง!! [Ver 2025]](http://i.ytimg.com/vi/20xn0g6k-ec/mqdefault.jpg)
It's not that hard to disassemble, but to put it back in... Hardest part is the spring. You have to twist it a good couple of times, so that it fits way down into plastic cover, while holding it's outer hooked end in a cut out in the cover. I did it by holding it in a vise with little nut pressing spring's hooked end and then twisted the spring with small pliers, while trying to push it down with a screwdriver. Then, you have to twist it even more with using that can carrier - you put inner hooked end of a spring in its cut out and then turn it counter-clockwise a good half turn, untill you put its protruding "leg: after a matching protruding "stopper" in a cover. Only then you mount everything in reverse. Took me half a day, good luck xD.
would like to see a video about that, because I have to put it back together and can't find a video about that.
I used a big slot screwdriver to put the spring back into place (just small turn an pushing it inside). After hours of trying this worked for me fine in a few seconds. no guarantee that you will break something.
Класне вiдео-менi допомогло! 👍
Привіт, у мене такий самий перемикач, перестав крутитися, я розібрав його там все було занедбано , а ось зібрати назад проблематично . Що саме ти мав на увазі в кінці відео махаючи пальцем, чого саме слід не робити? незрозумів.
make a video showing how to reassemble it and mount it back onto the wheel!!