DIY Building Motorcycle wheel Chock. Motorcycle wheel holder.

แชร์
ฝัง

ความคิดเห็น • 9

  • @pawestencel7738
    @pawestencel7738 5 ปีที่แล้ว +1

    Super sprawa ,jak dlamnie 5 za pracę. Jest szansa na wymiary zrobił bym dla siebie.

  • @DavidM2002
    @DavidM2002 6 หลายเดือนก่อน

    Good design but the pivot point could have been much lower and that would make getting in and out much easier.

  • @DavidM2002
    @DavidM2002 6 หลายเดือนก่อน +1

    Thank gawd for the Mute button.

  • @januszautograf5903
    @januszautograf5903 4 ปีที่แล้ว

    Na skuter i motocykl ten sam rozstaw, a podłoga to rozstaw tak koło 50/ 70 i długość, wysokość tak 50,profile 3*3 i 1*3 lub 4 blacha tak grubość tak 2,3 milimetry, dobrze wyliczylem 🤔🤔

  • @polsrimasittikul890
    @polsrimasittikul890 ปีที่แล้ว

    👍👍👍🙏

  • @bartekmulan14
    @bartekmulan14 3 ปีที่แล้ว

    Hej, czy mógłbyś podać wymiary tych korytek ?

  • @davairharris2613
    @davairharris2613 2 ปีที่แล้ว

    Are there any measurements for this

  • @BillyRillkratz
    @BillyRillkratz 2 ปีที่แล้ว +1

    Too flimsy

  • @markearnshaw7178
    @markearnshaw7178 7 หลายเดือนก่อน

    Complete fail bike will go over eventually.