Going Online With Simotion

A video tip and trick to show you how to set up SCOUT and your PC to go online with Simotion and Sinamics Integrated. This video assumes you're using ethernet to get connected with Simotion.

[@abdelhamidabdou3507]

very useful video I hope you will post more videos for simotion

[@ashwinhirpara6193]

❤

[@eaglelee952]

very nice teaching, thanks

[@lfbustillos]

Hello, thank you very much for the contribution, please could you tell me if it is possible to take the speed value of an axis to wincc, do you have any video on this? thank you very much

[@user-wt5eb4xq6z]

Thank for you video

[@sharadsingh847]

Thanx a lot for this sir but i have to change the hardware configuration as i have changed motor module with different mlfb no. plz help over this.hope to get info regarding this soon

[@eaglelee952]

2 question: the PLC and motion control all in this SIMOTION unit? how to upload PLC from SIMOTION? thanks

[@newsap2v5]

Dear Sir
At 2:09 there is a dialog "Add IP addresses/subnet masks". Yesterday I click yes in that dialog and the IP address of simotion controller D changed from 192.162.0.1 to 192.168.214.1. I want to ask you for help to change backward to origin address. Is there any way to do that?

[@tkserve]

Hello, I watched and try to do after you.
I would like to know that you assign your pg/pc already before you made this VDO ,right?
please explain to me because I cannot coonnect to integrated S120 it 's show that S120 off line.
I just connect to D445 and have a red clutch on the left tree menu.
Please let me know. My D445 was a red LED on ready ,SF, DP1and DP2 how should I do.
thaks in advances,
Kai from Thailand

[@vorapobautomation9760]

Can you explain How to upload project from TIA SIMOTION SCOUT without project backup.

[@ram2001able]

Have you souce available simotion scout 4.3 source?

[@vorapobautomation9760]

How to use Enable/disable simulation mode of a real axis