Just started refurbing a DP220 bench top I just picked up. It was enjoyable watching your vids and nice job on the drill. Problem is every time I watch one of your drill vids I want to go out in the garage and start working on mine no matter what time it is....
Hey Chris - this is a great video! Thank you for sharing! I am in the middle of restoring the exact same motor. so this was quite helpful! I am wondering if you can share the replacement bearings you used here, as I am trying to replace those on my motor. Thank you so much!
Sorry for the delay in my reply. I took a look and I am 99% sure I got these on Amazon, they're 15 mm ID, 35 mm OD, 12.7 mm Width, Single Seal/Shield. At the time I had to get one branded NTN and one Peer as that was all they had. Guessing you already found a source, if not I hope that helps. Thanks for watching.
Great video, I have an identical drill press i just bought last week and need to do a few repairs. I need a replacement pully for the top of the because mine is broken just like yours was. Where can I get a new pulley just like the one you got for mine? I have not had any luck finding on on-line. Thanks for your help.
Just started refurbing a DP220 bench top I just picked up. It was enjoyable watching your vids and nice job on the drill. Problem is every time I watch one of your drill vids I want to go out in the garage and start working on mine no matter what time it is....
Thanks for watching and I'm glad you found it enjoyable! Good luck with yours, once you get started it's hard to stop.
I HAVE THE SAME MODEL... RESTORED IT 30 YEARS AGO... LOVE IT PAID $40 FOR IT BACH THEN ...
Hey Chris - this is a great video! Thank you for sharing! I am in the middle of restoring the exact same motor. so this was quite helpful! I am wondering if you can share the replacement bearings you used here, as I am trying to replace those on my motor. Thank you so much!
Sorry for the delay in my reply. I took a look and I am 99% sure I got these on Amazon, they're 15 mm ID, 35 mm OD, 12.7 mm Width, Single Seal/Shield. At the time I had to get one branded NTN and one Peer as that was all they had. Guessing you already found a source, if not I hope that helps. Thanks for watching.
Great video, I have an identical drill press i just bought last week and need to do a few repairs. I need a replacement pully for the top of the because mine is broken just like yours was. Where can I get a new pulley just like the one you got for mine? I have not had any luck finding on on-line. Thanks for your help.
www.hammerscale.com/HTML/Products/DrillPress/DP220B.html