Datamax E4304 Media Hub and Labels Installation E-4304

1-Open the top of the printer by pressing the two blue bottons on the side of printer.
2-Lift the printhead by pressing back on the green tab.
3-Take the Media hub that holds the labels out.
4-put labels on the media hub and adjust the flange to accommodate the Labels.
5-Place the media Hub with Labels into the grooves on the printer.
6-Slide the Media guide to Accommodate the size labels.
7-Pull the labels toward you and make sure the media guide is against the side of the labels.
8-Make sure the labels can move easily through the media guide.
9-Make sure the media flange on the media hub is pressed against the labels as well.
10-Press the printhead down until locks into place.Make sure it locks!
11-Close the top of the printer.
12-Now the printer will need to calibrated.
 While the printer is OFF
 Press the F3 Button
 Turn the printer ON while Still pressing the F3 Button
 When the yellow paused light goes off,Take your finger off the F3 Button
 Press the F1 Button.The Paused light will blink 5 times and labels will cycle through the printer.
 Press F1 and F3 down at the same time to save the settings.
Now , in page setup select the size of label and send print.
MUMTAZ COMPUTERS
13 Ali Zaib Rd, Block J Gulberg III, Lahore
03444565050

[@AliAneesname]

Is ki setting kasy karty hein

[@rumifashion2572]

Brother ye software kon sa use kr rhy hen