Miss Mayhem FPV: Friday Fluffs
ฝัง
- เผยแพร่เมื่อ 27 มิ.ย. 2024
- #fpv #runcamthumb #nostab.
Very thick cloud, poor solar charging today, BAH !
Just when my batteries are low.
Music: Lo-fi miku - Happy Hour, Audio Library.
• Happy Hour - Lo-fi mik... . or
/ lofi-miku .
![[ LIVE ] Rank เล่นแต่แครี่ ยาวๆถึง 100ดาว “วันนี้มีกิจกรรมลุ้นรับสกินมาบอกต่อ โก๋แก่ช็อกโกบอล x ROV”](http://i.ytimg.com/vi/5NNgkhWj57Y/mqdefault.jpg)
Those cactus flowers are beautiful TS. The Pure Purple watch is cool too. Im glad you found the likely culprit in the desoldered motor wire. My OX-35 had similar problems recently. I just resoldered and reflowed all the joints, but did end up replacing the ESC. Also it might be worth a good look at your capacitor. Mine showed signs of excessive heat so I replaced it at the same time as the ESC. I'm no electrical engineer. I'm just relaying my experience in hopes it may help. Thanks for sharing your adventures TS. Happy flying amigo. 🫡 🍻
She's over 4 years old, most kwads don't survive that long, LOL. I don't really fly hard and kill stuff nowadays. Happy Flying amigo.
@@TailSpinRCSpain I'll be interested to learn what fixes it.🤠👍
Just going out to test her in a minute, charging a pack now.
@@TailSpinRCSpain 🤠👍
not sure i seen any symptoms that time but if you feel it not doing what you expect... thats bad. i think if the esc was bad it would desync a lot? i had a silicone signal wire that was damaged, doesnt take much. there must have been just a few strands of copper left passing the signal and it was a struggle to troubleshoot. but if it doesnt feel right, its gonna fail. i know its hard but maybe its the frame, tiny delaminations you could barely detect by looking or bending the arms can cause odd performance issues. you should maybe get over to rimzlers channel and pick a new frame, and retire miss mayhem ontot the wall of fame hehehe
ps. i dont even know what a mosfet really is hehehe.
@@TheMadmacs Wires are all fine, no nicks, not had any de-syncs either, got me stumped.
Addendum... just checked the phase wires on the ESC again, one solder joint fell off when I touched it !!! It was motor #1, not #2, but I'm still not sure why she dipped to the left front corner. Will test fly her tomorrow, too hot now at 14:23h.
@@TailSpinRCSpain uuuhm how long since you soldered it? maybe i should check my builds hehehe, thats my first troubleshoot tip, go around tapping all the wires to see if it changes anything ehehee. my solder work is truly awful, like i'd used a butter knife hehe, i really should check them, few years old now. i dont crash much but when i do its a biggy.
Really not had to do much to her over her lifetime.
One motor, VTx antenna and some props, the RunCam Split 3 died without any help from my bad flying, LOL