How To Adjust the Flame on a Cutting Torch?
ฝัง
- เผยแพร่เมื่อ 15 ก.ย. 2024
- On tonight's' video Matt Arnold shows us how to adjust the flame on a oxy-acetylene torch. Properly adjusting the flame on an oxy-fuel torch is essential to get a clean perfect cut!
#Welding #WeldTube #WeldLife
WeldTube Store
www.weldlife.com/
WeldTube Social Media
Instagram: / weldtube
Facebook: / weldtube
TikTok: www.tiktok.com...
👇WeldTube Store👇
www.weldlife.com
People actually learn from him. I mean how lucky are they? Homie been putting out great content since for ever. 🔥🔥🔥 great info. This is what either keeps you till the end! Or you getting laid off next to the bolt up crew. Learn it all guys. And learn it from the right folks. Like this gentleman!! 💯💯💯💯
Great info and tips on the GAS AXE guy. I always reminded my welding students to make sure the OXY valve at the bottom of the torch handle [on the combination torch you are using] is FULLY OPENED or it will starve the cutting jet stream of OXY when the cutting handle is pressed.
Nice tip. Thanks!!
Nice and clear instructions 👌 💯👊👍
🤙🤙
This works for sure but my instructor taught me a little different. I was taught that it's right when the flame get smaller when you press the lever.
Hopefully someday you all can show us how to cut
Good explained
Nice information sir thanks a lot
Can you do a comparison with oxy-propane?
i always open the oxygen closest to hands to full,, and only uses the top one..
Very good 👍
What’s the problem when your oxygen continues to blow through your torn and when you press the oxygen trigger on your torch it does nothing . I’ve never seen this before . Bought a new torch head ( no change ) . I’m stumped
Sou soldador brasileiro gostaria muito de trabalhar com vocês
Woow Good ❤❤🎉😊
💯
🤙🤙
When you open your gas valve crack your oxygen open and you will have no soot floating around especially in a food industry
Just make sure it's hot nuff to roast your 🌭
🤣🤣