Now i totaled the whole cutting bar. the long bolt shaft what runs trought the section is bend. it is 280 long. or lely 550p it has 2 bars. But where i can get that long bolt?
Im not sure is my hex driver shaft little bit rounded, but seems to be nightmare to get it timed right so that the first two blades do not touch each other.
You can time it with the teeth on the gears as well, so when you're assembling each bed section, leave the bolts loose so you can adjust them a couple of degrees or so by the teeth, if that makes sense
@@seggonscontractors588 i did that, but seem that the drive shaft is so wornout that those hit what ever i do. So i took little bit off those blades with angle grinder.
Was it hard to seperate the drive to get to the gears on part at 7:37
Not on this one no! They can be abit of a pig sometimes but normally once they start moving they're alright
Now i totaled the whole cutting bar. the long bolt shaft what runs trought the section is bend. it is 280 long. or lely 550p it has 2 bars. But where i can get that long bolt?
Im not sure is my hex driver shaft little bit rounded, but seems to be nightmare to get it timed right so that the first two blades do not touch each other.
You can time it with the teeth on the gears as well, so when you're assembling each bed section, leave the bolts loose so you can adjust them a couple of degrees or so by the teeth, if that makes sense
@@seggonscontractors588 i did that, but seem that the drive shaft is so wornout that those hit what ever i do. So i took little bit off those blades with angle grinder.
Thanks !!
Glad to be of assistance 😊