Napravi sam oplodnjak za matice - DIY bee queen mating nucs
ฝัง
- เผยแพร่เมื่อ 18 ต.ค. 2024
- In this case the starting point to make a mating nuc is a small frame which fits inside of a Farrar frame. The same could be applied to any other hive and frame standard, LR, DB,...etc. We only need to adjust a number of small frames and their dimensions so they can fit inside of a bigger frame.
Outer dimensions of a small frame are 136mm x 142mm. Top and low frame bar have an opening. It's used to insert a wax foundation. On the top bar there are two metal pieces on each side. One of it slides back and forth depending if we're putting small frames inside of a mating nuc or aligning it in a bigger frame. We can also add a fifth frame, as a feeder or a normal frame. Instead of this frame feeder we can use a jar lid on the top of the frames, below ventilation.
Body measures of a mating nuc are: 168mm H x 230mm W x 198mm. This measurements can little differ.
Entrance is 56mm from the bottom. Ventilation is 38mm high.
A roof on its top has 20mm polystyrene, 5-layer water resistant plywood and a thin metal cover. Roof dimensions are: 16mm wood thickness, it's 80 mm high, with roof 236mm long and 264mm wide.
The whole nuc instead of wood could be also made of a polystyrene.
hvala na podijeli znanja !!
Hvala što nas pratite. Medno!
Moze li se znati duzina oplodnjaka
Fantasticno
nash chelovek ,bravo
Jel imate neki snimak kako formirate oplodnjake, pre ubacivanja neoplodj. matica ili maticnjaka?
Kada se pcela ubaci u oplodnjak , da li ona prezimljava u njemu?
Pozz
Gdje si nabavio te limove na satonosama
Da je crnogorac pricao brze bi izgovorio misao,
Iskomplikovo si i rastego pricu
Odustajem