46 degree is elbo or rolling I am confused, Please tell me that I am your subscriber, I watch all your videos, if there is a problem, sometimes I watch it, please clear the confusion.
What if the elbow used is 45° and a 22° elbow is added later to align the pipeline correctly...then can I calculate roll and run correctly with 67° as the angle since pipeline is inside ships engine room and hard to access
Sorry Bro, I am not much familiar with the Imperial units. I think it is better, to convert the inches to mm, then calculate, then convert back to inches. Thank you.
@@technicalstudies. Sir the 46.8 degree is the elbow miter cut? So we need to cut a 2pcs of 90 degree elbow into 47 degree? Hoping for your positive response
When I draw in the AutoCAD the run=1200, roll=800, and set=1200 then the travel length is 2030. But according to your formula the travel length is 1755. where is problem?
Very simple calculation, I enjoyed it. You make my job simple.
Thank you Bro.
46 degree is elbo or rolling I am confused, Please tell me that I am your subscriber, I watch all your videos, if there is a problem, sometimes I watch it, please clear the confusion.
Very simple calculation
Thank you.
Thanks for the clarification
Thanks Bro.
How did you use the calculator to get your answer
What if the elbow used is 45° and a 22° elbow is added later to align the pipeline correctly...then can I calculate roll and run correctly with 67° as the angle since pipeline is inside ships engine room and hard to access
Oke Im understand sir right now
Thank you Bro.
It’s so simple .
Thank you
You are welcome 😊
Supeb
Thank you.
Does this work with Imperial units too?
Sorry Bro, I am not much familiar with the Imperial units. I think it is better, to convert the inches to mm, then calculate, then convert back to inches. Thank you.
@@technicalstudies. Yes
Opposite side elbow how long horizontal direction and vertical direction?
OK Bro. Thank you for the suggestion.
46 degree rolling elbow or material for neppel sir
Bhai, this is a general procedure for any degree. Applicable for 25, 30, 45, 60 degrees. Thank you for the comment.
Pls make it clear on the answer 46.8
Bro, how could anybody explain more clear than this.
@@technicalstudies. Sir the 46.8 degree is the elbow miter cut? So we need to cut a 2pcs of 90 degree elbow into 47 degree? Hoping for your positive response
Thank you vry much
Thank you Bro.
When I draw in the AutoCAD the run=1200, roll=800, and set=1200 then the travel length is 2030. But according to your formula the travel length is 1755. where is problem?
Square root of (1200+1200+800)- 2 elbow centers. This is the true length of the pipe.
I want you to make new videos
only 45 digree
OK. Please watch this video and comment. th-cam.com/video/FXzQeUVt2eE/w-d-xo.html
So would the top elbow be 90 degrees -46 degrees
No. Same degree as the bottom elbow.