@joannewilliams5981 Hi, when using the mosmatic surface cleaner, you can only go to 120° or it will damage the bearings. Also, for getting a better clean, you really need 250 bar pressure, any less, to be honest, is a bit naff.If you are using just a lance, then you can use around 100 bar upwards just see what works best. A turbo nozzle can be used to I think ? 90° I don't use the turbo nozzle much though, on this job, we went to about 120° it was enough heat, I started 25 yrs ago using just cold water since using heat it's a massive difference, but you need so much equipment as problems always arise. If you are starting out, I wouldn't have a machine that uses more than 15 litres per minute of water as you will most of the time keep running out and waiting for your water bowser to fill up. Any more questions, just ask. Thank you.
What psi and temp do you use mate
@joannewilliams5981 Hi, when using the mosmatic surface cleaner, you can only go to 120° or it will damage the bearings. Also, for getting a better clean, you really need 250 bar pressure, any less, to be honest, is a bit naff.If you are using just a lance, then you can use around 100 bar upwards just see what works best. A turbo nozzle can be used to I think ? 90° I don't use the turbo nozzle much though, on this job, we went to about 120° it was enough heat, I started 25 yrs ago using just cold water since using heat it's a massive difference, but you need so much equipment as problems always arise. If you are starting out, I wouldn't have a machine that uses more than 15 litres per minute of water as you will most of the time keep running out and waiting for your water bowser to fill up. Any more questions, just ask. Thank you.