🟡 RC TRAINER For Beginners and a lot of Fun | INDESTRUCTIBLE | EZ DIY
ฝัง
- เผยแพร่เมื่อ 11 พ.ค. 2024
- I have a lot of fun with this EZ Trainer. Perfect for training or just relax flying. Low Fly-Bys are always very enjoyable.
It can fly quite fast on full throttle but I also like to fly on the lower limit - as little throttle as possible and close to the terrain.
DIY Cheap Easy RC Plane Trainer for beginners.
Indestructible - Unbreakable - Modular
Airplane:
-----------------------
Wingspan: 1000mm
Wing chord: 230mm
Fuselage: 800mm
AUW: 900g
HW:
-----------------------
(TX: Taranis Q7XS + RadioMaster Ranger Micro ELRS)
RX: MatekSys ELRS-R24-S
Controller: MatekSys CRSF-PWM-C
Battery: DIY 3S SAMSUNG INR18650-25R
Servos: AliExpress MG90s
Gyro: Ali 3 Axis Gyro A3 V2
ESC: Ali 40A 2S-4S
Motor: Ali 2212 1400KV
Prop: APC 9x6E
-----------------------
#rcplane #trainer #rc #diy - บันเทิง
Wonderful! Your video was full of great ideas. I love it when RC aviation and 3D printing collide. 😊
Hello and thank you very much 😊 yeah 3D printing is amazing for many things
I like your mid-wing mounting idea for it's flexibility & durability. Very nice build!
Thank you 😊 it's more fun when you can crash it 😅
Plane also a lawnmower 😅 really nice job
Haha 😅 thank you 😊
Did you spot-weld tabs on the 18650 cells? Never mind - I found the answer on another of your videos. Thanks!
Was it possible to using nicely without gyro? Do you advice to use gyro?
After the polyhedral modification, It was significantly easier to fly. I´d use GYRO in few situations. New built plane or if I am not a good pilot (or for relax safe flight). At least It´s extra safety and stability. Huge advantage is that you can disable GYRO in the air to fly fully manual when you feel for it or feel if the plane struggles so you can tune it closer to perfection.
On the other hand, If you don´t want to have extra cost (still very cheap GYRO on Ali) or electronics in the plane, well designed plane should be stable. There are few nice videos about plane stability. But honestly, I´d still use GYRO at least for maiden flight, and because it´s no soldering, just connectors, you can put it out anytime :))