2024 Integra Type S - Hard Wiring a Radar Detector

แชร์
ฝัง
  • เผยแพร่เมื่อ 28 พ.ย. 2024

ความคิดเห็น • 9

  • @anthonys6657
    @anthonys6657 3 หลายเดือนก่อน +1

    I have a 2024 Aspec 6MT. Your video saved me a lot of time because it’s the exact same set up in my car. Thank you very much.

  • @augachong
    @augachong ปีที่แล้ว +1

    Thanks for sharing this. This was the only video specific to Integra. I have 24 MY Aspec tech package and worked on the first try.

  • @Iceforfree
    @Iceforfree ปีที่แล้ว +2

    thank you for posting this!

  • @Han-fx4bz
    @Han-fx4bz ปีที่แล้ว

    my car is 2023 civic hatchback spot touring. It’s a top trim and everything looks same under that plastic cover.
    I’m trying to do mirror tap to get power for my radar detector from mirror. After that, the system says “Supplemental restraint system problem”. I’m sure there is no short on any wires. It might be an error.
    I don’t have any power if I put in the red. I can only get power when I put red wire into the yellow wire. Also, it’s a continuous power. I also used a meter to find the on and off power, but they all have the power all the time.

  • @julianuk3266
    @julianuk3266 10 หลายเดือนก่อน

    i have my mirror tap arriving tomorrow AM, i hope i don't have any problems getting the shroud off. Last time i hardwired on a VW and actually on my son's KIA, i ran the wires behind the headliner, and down the pillar straight into the fuses. i guess if i can't get it off, i'll do the same. But i like the idea of going straight into the mirror.

    • @anthonys6657
      @anthonys6657 3 หลายเดือนก่อน

      Just to add onto your comment, I tried running a hardwire down my a-pillar on the driver side of my Integra and I didn’t feel comfortable running the wire in front of the airbag. I ended up doing the mirror tap method.

  • @tdlondon
    @tdlondon 8 หลายเดือนก่อน

    I did the mod ok but I feel like the new mirror doesn’t stay tight holding the socket. Just with the force of setting the mirror it kind of wants to wobble out of the socket. Is this normal? All clamps seem to be in the right place

  • @jamwest3146
    @jamwest3146 ปีที่แล้ว

    Hi, I had the dealer install my detector, but they did not feel the Blendmount would work. Now I want to install a vehicle tracker into my OBD port. Do you know where it is located. I have a Red ITS.

    • @StickerFab
      @StickerFab  ปีที่แล้ว

      Pretty much the same location in every vehicle so easy to find! Look towards the fuses that I pointed out in the video. It is right inside the door but tucked up and facing down.