Yukon Hybrid Battery Charging
ฝัง
- เผยแพร่เมื่อ 17 ต.ค. 2024
- In this video,we are going to show the hybrid cumminity and hybrid owners, who want to recondition their Yukon hybrid battery packs, how to use a Grid Charger or a High Speed Charger to charge the hybrid battery pack. The battery pack may be charged while inside or outside on a bench. You will use the High speed Charger in two halves, while the Grid Charger can chjarge the whole pack in one go. Enjoy.
I just received my grid charger. My spare core went from 300V to 340 V overnight. I permanently installed the wires in my '13 Silverado as per the last few min of this video and drilled a hole in the centre of the front plate and put in a grommet to keep the wires safe. I am charging my Silverado now. To prevent anyone from starting the truck while on charge I clipped the keys to the charging cable :), I plan to add a relay to prevent this from ever happening by accident. I'll post results in this comment as Chevy Hybrid info is tough to come by.
"Information tough to come by" You can say that again. I have 09 Tahoe Hybrid with very low miles and while not well used is old. Not much info out there for GM Hybrid owners, mostly Toyota stuff or Honda.
Once you install permanently, do you need to disconnect the high voltage wires or 12v? Or keep everything together and not turn the key and your fine?
Has the MPG increased or it's just to prevent from having buy another battery?
Where did you purchase your grid charger.
Is it possible to use a 12v or solar charger for this?
How do you recharge them What kind of charger can you show it in the picture?
Love ur videos! Do u know wat the wire harness on da POLARITY side is called? Mine looks burnt at the connection point to the battery ecm/or brain of hybrid battery.. Thank You!
Please contact us at info@venicehybriddtech.com for a replacement.
Hello, I’m looking at a 08 Yukon hybrid. How often should you charge the hybrid battery? Does this help with the life of the battery? Is there a special charger I should buy?
Have a dead 300v in 2009 silverado hybrid 2 mode, with my xtool, and a new hybrid battery to put into truck ..what else will I need and what is process to install 300v properly to get truck running?
My car was parked for four months now the battery is dead. How do I charge them? I’m not talking about the 12 v Battery I’m talking the big battery how to charge it and what kind of a charger can you share the picture of it thank you.
I have a video, which you can watch.
Hello, they sell me a 2011 Yukon Denali hybrid, but the owner says that the battery does not work and that it is necessary to tow, it could be the battery, I have doubts before buying it, please, I don't know if you can help me, he sells it to me in 2500. but it would need a battery
The hybrid battery can be fixed. Where are you located???? The price seems pretty good.
ok why are we not splitting up charging inside the vehichle? When on bench we must only charge one half at time!?
Hi Terry, You have not understood the contents of the video properly. This video is explaining how to use a High Speed charger which has a max voltage of 285V. Hence, it is not capable of charging the whole pack at once. However, if you use my Grid Chargers for Yukon Hybrid, they are capable of charging the whole pack at once as the voltage is higher. So it will depend upon what charger you are using and what is output of that charger. Hope that helps.
@@VeniceHybridTech so I'm assuming on a bench we only charge 20 sections at a time positive and negative? Inside the vehicle you're telling us to charge 40 packages that one time within the vehicle bolted down to the back seat floor in a 2011 Chevrolet Tahoe hybrid? Do I stand correct? Or am I wrong? You clearly do not show in the video inside of a vehicle where it's a permanently mount your base charger and clearly if I'm going to spend that kind of money I'm going to spend double the money and charge. Everybody's hybrid in my area because there's nobody that can pull this off in my area
@@latunguley Hi , I will repeat myself again. It depends upon what kind of a charger you order!!!!!!!!!!!! I have chargers with different outputs, so if you order a charger with output of 400 V, you can charge the whole pack, whether inside or outside the vehicle. However if you order a charger with 285 V output, you will be charging in two halves. I suggest you email me at info@venicehybridtech.com or call me at 424 227 6719. Thanks.
@@VeniceHybridTech thank you. Now you're making sense to me
Does this hybrid vehicles like a 2011 gmc sierra hybrid use the hybrid battery to crank the truck because I'm have a no crank issue and my truck has been setting for about 6 months
Yes.
@@VeniceHybridTech I know it doesn't have a starter like a normal truck does, so what turns the motor to crank?
MG1.
@Venice Hybrid Tech another question would any high speed charger work as far as trying to connect it to the terminals I noticed on the cells the have little room
The HSC has crocodile clips at the end of wire harness which can clip onto any terminal.
Hi,
How much is the charger please, I am looking a charger which can help me to charge Toyota Prius battery as well. Please could you advice how much would you charge for charger and shipment to UK?
Kind regards
Hi, please contact me for via email: info@venicehybridtech.com
Thanks
Hello. Is the voltage to charge one of the dc or ac. Trying to see what I need for a charger. Or if I can use 120v ac
Batteries are DC (Direct Current). The fact that you dont know that tells me you should not be screwing around with ANY electricity or batteries.
What's the amp level for charging each half of the battery
You can charge at 350 mA, 500 mA or any other rate suitable to what charger you can get!!!!!!!!!!!!!!
Are you able to charge the whole thing instead of charging in halfs?
Hi, Yes you are able to charge the whole pack in one go but you need a special charger. I have created a charger especially for Yukon Hybrid that charges the whole battery pack at the same time. Contact me at info@venicehybridtech.com
Cadillac Escalade hybrid will this work
Hello my friend, I took the battery pack out of my 11 Yukon to clean it and check volts. I installed it back in the truck but now it won’t start. It just says service hybrid system….any help would be great, thank you for your time!
First check your safety plug. Is it inserted properly and pressed down!!!!!!! Then you may have left some connections open or some bus bar connections could be loose or defective.
Do you have any codes on your HPCM? If so you may need to reset your 300V system with an advanced scan tool. I had a no start condition until this was reset. I then recharged my hybrid battery with jump assist.
Have a dead 300v in 2009 silverado hybrid 2 mode, with my xtool, and a new hybrid battery to put into truck ..what else will I need and what is process to install properly to get truck running?
Did you figure out the issue? I have something similar happening
Hi, a 2009 chevy tahoe hybrid code P1A20. Do we need to jump-assist it with a tech 2? I think it showing 0 volts
We found out that the safety pin/plug was nit in properly this whole time. So code P1A20 only code showing up after we properly made sure it's in right
I am sorry but I am not sure what you are asking????? If it reads 0 V, then you will need a charger. You can not jump start it. Thanks.
My code is now saying P0bc3? 227volts how do I charge with the battery in the truck
@@elizabeth838 Hi, here is a link for you to read and do the needful. www.engine-codes.com/p0bc3.html
@Venice Hybrid Tech ok thank you. I emailed you because we wanted to know what grind charger we need for the 09 tahoe I didn't see it on the website
Why do you charge the battery? Is there another benefit other than top balancing the batteries?
The Grid Chargers and High Speed Chargers are used to charge and balance the battery packs. Yes there is a need to charge the hybrid batteries as the systems in the hybrid vehicles do not do a proper and full capacity charge. These systems also get old and do not perform all the time at their peak performance. The batteries then start getting weaker and weaker.
@@VeniceHybridTechwill this bring back to life a dying battery? It's a 2008 still starts (barely) but as auto stop doesn't work and runs strangely.
@@davidccoulombe Mostly, I will say 80% of the times, the hybrid pack is either weak or unbalanced. hence the charger will help in taking care of both of those. However, if the battery pack has a few dead modules, then those will need to be replaced before the battery will start functioning properly. You might still need a charger.
@@VeniceHybridTechthanks for this. What is the nominal voltage per cell? Is it possible to use a 60v DC charger and charge x amount of cells at a time? I live in a remote location and need to fix with what I've got here
@@davidccoulombe Hi David, these are the same modules which are used in all Toyota models. The nominal voltage is 7.2 V but they can easily go up to 8-8.3 V. You should be able to charge them with your charger. good luck.
How do I order the most inexpensive high voltage charger
Please Contact us via email info@venicehybridtech.com
Would you please I have 09 Tahoe it doesn't start it keep saying contact relay for the hybrid battery is open
P1ae4
Motor 1
Motor 2
P1b05
P1b05
Please help
Hi, there are two contact relays inside hybrid battery, also called contractors, one for the +ve wire and one for the _Ve wire. Check them, may be one of them is faulty. You can find some video on how to check the relays.
@@VeniceHybridTech Do you know the part numbers for those contactors? or where I could buy them?
السلام عليكم ورحمة الله وبركاته
كيفكم اخباركم
كل الحب و الاحترام
كيف يمكن شحن بطارية سيارتي جي ام سي يوكن هايبرد ٢٠٠٩ هنا في المملكه الاردنيه الهاشميه لطفا