Designing of Plastic Products for Injection Moulding - Lecture Snap Fit Less Than 90

A course on Designing of Plastic Products for Injection Moulding was conducted by Prof. Vijay Bapat at IDC, IIT Bombay. The proper knowledge of materials and their manufacturing process helps a designer to select the best material as per its application. A good designer always considers the limitations and constraints of the materials in the design phase since materials not only affect the aesthetics of a product but also decide its manufacturing cost. This clip is about snap-fit less than 90.
For more information visit: www.dsource.in/course/designi...
Write to us at [e-mail]

[@prashantverma7246]

Amazing sir
Salute you

[@pravinpadale8787]

As usual very insightful sir.

[@dineshkadam2952]

Nice video sir,
Can u solve my one quriery.
How much clearence we'll make with surrounding part. While design a snap?
If possible please make small video on it.

[@shannybabayaga]

I was expecting cantilever snap joint design and forces using a flexural modulus explanation.

[@tanurajbhattacharjee]

Where can we get the complete lectures. Please let me know

[@dsourceindia]

For more information visit: www.dsource.in/course/designing-plastic-products-injection-moulding

[@adithya3992]

max cos is possible if it is 0 degree? am i wrong?

[@TheVistastube]

Cos 45 is minimum for both directions, i.e. opening and closing.

[@amolaegade5428]

i was also thinking the same

[@RoyKrugman]

What the major name is?

[@dsourceindia]

For more information visit
www.dsource.in/course/designin...

[@suniltammati184]

Sir can I get your contact no..for any plastic design queries as I m working on automotive interiors plastic

[@pvn.b]

Sir gimme your number I will contact you for any queries!

[@gopimadasu2944]

Where are you working bayya