I was lucky enough to have a father in law that worked at and purchased electronics parts from Lockheed Martin. I had what I needed in the tacklebox of electronics he left me. I did see them on Amazon as well. Good Luck
Actually the remote works so well I never felt the need. Everything is still working great. I do feel that the jacks themselves will be an issue and I will be looking for an alternative if I have any failures. If anyone comes up with a solution that allows leaving the atwood system in place, please let us know!
Thank you for your info, that is my worry, the actual jacks going bad. I just bought my rig and the previous owner said they would go down but not back up…
Still working great after almost 2 1/2 years. One of my jacks is starting to have a little clutch noise but for the money this system works excellent-Just don't forget that you no longer have any warning that your jacks are down when you drive off.
Thanks for making the video. I have a CHEVY Duramax motor home with a defective board....water damage because the builder mounted the circuit board flat on the inside bottom of a basement compartment. I could only find a FORD board which I found is wired differently. I may get the GAMA control and was curious why the 10 screw connections on the top edge of the board. Glad it worked out for you. JwgK in Houston TX
Just ordered this system cant wait to replace that atwood junk!
To the beat of my recollection, it was labeled positive and negative. You can always use your multimeter to see which leg is the hot side?
My connector was front right and rear right
How did you know which one of the two wires from the old panel was the positive and negative for the new panel? Or does it not matter?
Is it still working? I’m looking at ordering one this week
Did you end up making a hard wired panel a to repla asby
I could buy a new motor home foe worth of my wife
Yes, working great!
I just got mine today and gonna hook it up
Mine is still working great. Good.luck!
Where did you get he ring connectors
I can only find them for 10 and 12 ire not good fit for the 10 it loses some of the wire when I push it in
I was lucky enough to have a father in law that worked at and purchased electronics parts from Lockheed Martin. I had what I needed in the tacklebox of electronics he left me. I did see them on Amazon as well. Good Luck
Actually the remote works so well I never felt the need. Everything is still working great. I do feel that the jacks themselves will be an issue and I will be looking for an alternative if I have any failures. If anyone comes up with a solution that allows leaving the atwood system in place, please let us know!
Thank you for your info, that is my worry, the actual jacks going bad. I just bought my rig and the previous owner said they would go down but not back up…
That may be a controller issue?@@bounderchris
Thanks
You did a great job for your first video. Just ordered.
Still working great after almost 2 1/2 years. One of my jacks is starting to have a little clutch noise but for the money this system works excellent-Just don't forget that you no longer have any warning that your jacks are down when you drive off.
Thanks for making the video. I have a CHEVY Duramax motor home with a defective board....water damage because the builder mounted the circuit board flat on the inside bottom of a basement compartment. I could only find a FORD board which I found is wired differently. I may get the GAMA control and was curious why the 10 screw connections on the top edge of the board. Glad it worked out for you. JwgK in Houston TX
Those additional screws are for manual/momentary switches
Pretty simple install-Still works great!