Hi, I tried the same thing for an hour or so and could not get the adjustment bar to move in the green area. Switch to 10x mode :) Also, look at the picture in the first screen, it's supposed to work without the ground cable: remove the hook thingi, put the tip into the P0 latch from the left side, and make sure the probes metal ring is positioned inside the ground connector to the left of P0. The probe should be nearly horizontal with the cable facing left :D not sure if it makes a difference over your setup though...
Thanks. I did eventually figure this out once I found the probe calibration setup in scope. It has a pitcture of the probe properly seated for adjustment.
In the beginning he said "Rigol RTB2004".
lol good catch
Probe to bnc adapter: caltest ct2708
Hi, I tried the same thing for an hour or so and could not get the adjustment bar to move in the green area. Switch to 10x mode :) Also, look at the picture in the first screen, it's supposed to work without the ground cable: remove the hook thingi, put the tip into the P0 latch from the left side, and make sure the probes metal ring is positioned inside the ground connector to the left of P0. The probe should be nearly horizontal with the cable facing left :D not sure if it makes a difference over your setup though...
Thanks. I did eventually figure this out once I found the probe calibration setup in scope. It has a pitcture of the probe properly seated for adjustment.