Castor and camber is in the spindle. The an arms should be level. And have appropriately 3 to 4 degrees negative caster with a small amount of positive camber maybe 1/2 degree or so have fun kids building your dreams
Nice, i bought plans too and all my pieces are printed. I'm going to make the tubes structure and look for buying electronic parts; where did you bought yours...Ebay, Amazon, aliexpres? Did you finish the table and work with? Wich cutter do you use with? Thanks
I have not even started on the table yet!!! Hope to very soon, Just been very busy. I got all my electronics from Amazon and got the same plasma that JDs using also came from Amazon
God bless JD’s garage.
yes sir, never thought I would build my own CNC plasma table!?
I must admit I'm looking forward to this builds progress so I'm subscribing.
Cool thx, prob will not get on it until fall! Just way too much going on this summer!!
Hey not sure if you have been watching but I’m finally getting around to building this plasma table
Castor and camber is in the spindle. The an arms should be level. And have appropriately 3 to 4 degrees negative caster with a small amount of positive camber maybe 1/2 degree or so have fun kids building your dreams
Very cool, I can't wait to see the build of the plasma table. I also purchased from JD's Garage and am gathering parts to start my build.
Right on
oh that's cool
Thx 👍🏻
👍🏻☝🏻
👍🏻
We got us a Stv 5x10 table it’s a game changer for us
Nice, I’ve been so busy! but eventually I will get to mine im fired up for it
Thanks for the shout out! I didnt see any footage from the Saturday night escapade, maybe that was a good thing.
It was fun, we will look you up next time we’re in town
I would never leave the garage if I had one of these
So many tools so little money!!
Nice, i bought plans too and all my pieces are printed. I'm going to make the tubes structure and look for buying electronic parts; where did you bought yours...Ebay, Amazon, aliexpres?
Did you finish the table and work with? Wich cutter do you use with?
Thanks
I have not even started on the table yet!!! Hope to very soon, Just been very busy. I got all my electronics from Amazon and got the same plasma that JDs using also came from Amazon
Where’s the flux capacitor?
I may have to steal it from the car puddle