I love this setup! No grunt work! Could you process a thicker log? What did you do to get that attachment attached to the excavator? I wish the video was longer...
@@kylehathcock861 it hooks up to anything with a common skidsteer coupler. I need 15.5gpm at 2,850psi as a minimum spec. Yes your MT machine should be able to hook to it.
I love this setup! No grunt work! Could you process a thicker log? What did you do to get that attachment attached to the excavator? I wish the video was longer...
AWESOME VIDEO ! I THINK THIS MAY BE THE BEST MACHINE FOR THIS ATTACHMENT IF YOU HAVE AN EXCAVATOR ~
we built a bracket for my E-60. Just haven't had a chance to "play" yet
Mt100 specs say 2900 psi at 12 gpm.will it just run slowly?
I believe with the 120 unit we can get away with 12 gpm, however more is always better. Call me 570-690-4051 thx AJ
Check out the rest of the channel. I have the 140b processing a 20” oak
Do you have to add extra controller.or it just runs off the thumb hookup?
There’s an “in cab” harness setup. It’s designed to run off a 14-pin plug/harness, but if you don’t have that, then we do the in cab harness
@@ShaverSalesINC will it hook up to a bobcat mt85 or mt100?
@@kylehathcock861 it hooks up to anything with a common skidsteer coupler. I need 15.5gpm at 2,850psi as a minimum spec. Yes your MT machine should be able to hook to it.
Is it the same controller setup on the front of the tractor?
Homemade bracket to connect excavator pins to skidsteer mounts