Dear sir, While doing loop test of Temposonic(inductive) transducer, for full open (4mA) and full close(20mA) set, it shows nearly 3 mA for full open and 17mA for Full close. Could you assist me in it? And please make any video on practicle problem faced during scaling, calibration or loop test. Thanks
Hello Om Prakash Thanks for asking this question. It looks like your Temposonic transducer's calibration has been disturbed. This is a reason that you are getting low value of mA. In this case, you need to adjust zero and span until you get 4 mA and 20 mA respectively.
![Pressure Transmitter Workshop Re-range - [HART 475 / Fluke 789 / Druck DPI610 / Foxborough TX]](http://i.ytimg.com/vi/L7T92J7wpzE/mqdefault.jpg)
Dear sir,
While doing loop test of Temposonic(inductive) transducer, for full open (4mA) and full close(20mA) set,
it shows nearly 3 mA for full open and 17mA for Full close. Could you assist me in it? And please make any video on practicle problem faced during scaling, calibration or loop test. Thanks
Hello Om Prakash
Thanks for asking this question. It looks like your Temposonic transducer's calibration has been disturbed. This is a reason that you are getting low value of mA. In this case, you need to adjust zero and span until you get 4 mA and 20 mA respectively.
Loop check in hazardous location. Video please
Hello Udayasekhar
Thanks for your suggestion.