hello! i see that you have an o-ring left over near the end of the rebuild.. do you know where it goes? ive used all the seals in my kit and have the same o-ring left over
The oring goes under the Teflon seal on the main steel shaft mine didnt have it but the service manual says to replace it I had allready changed the Teflon seal it was too late
Video is a god send. Just doing the rack in my Soarer now. My bearings were unfortunately lunched though
Awesome mate most comprehensive I've seen so far thanks
40:15 but when you put the rack inside the tube it will damage the oil ring...
Amaising. Thanks alot. Really appreciated. Thanks Again!
Thank you for this. Looks quite difficult. I'm wondering if I should do this myself or not.
Wow thanks for sharing this !
Very welcome mate
Same rack for jzz30 and uzz30 this one is rhd. Tnks for share.
What is that electric connector for on the rack?
Its for high and low flow low at high way speeds and high at slow speeds not sure if mine even works lol
hello! i see that you have an o-ring left over near the end of the rebuild.. do you know where it goes? ive used all the seals in my kit and have the same o-ring left over
The oring goes under the Teflon seal on the main steel shaft mine didnt have it but the service manual says to replace it I had allready changed the Teflon seal it was too late
Thank you!
thank you
Only 1.9nm for preload? Can anybody confirm this
Preload 1.0 to 1.9 nm