SolidWorks Tutorial 2020, Exercise nr. 33 Gear Shaft! Learn from Home! :D

Hello friends, and welcome back on my channel, in this video I am making another easy part for beginners, I hope I am helping you with this videos to learn SolidWorks faster! If you have any parts like this and you want a tutorial about them, leave a comment, and I will answer you as fast as I can :D
Thank you for watching, and I hope to see you in the next videooo :D see you!
And if you want to support me, you can leave a like/share or subscribe :D
Here is my Facebook page where I am posting some of the drawings that I am using for my videos :)
/ alexs-engineering-1146...
-How to activate "Dynamic mirror entities" see in this Tutorial:
• SolidWorks Double Bear...
-How to limit Movement in Assembly:
• How to LIMIT the MOVEM...
-How to make a MOLD:
• How to make a MOLD in ...
-How to use BELT/CHAIN command:
• How to use BELT/CHAIN ...
-How to make EXPLODE VIEW:
• Explode View!! SolidWo...
Sownload drawing from here: www.pinterest....

[@sashasavic8324]

Zdravo Aleksa.Lepo je to sto si nam prezentovao u SW ali pokusaj da ubrzas dizajn tako sto cec koristiti zupcanike iz biblioteka pa ih onda kobinujes as ostalim dizajnom tela zupcanika.Tako ces brze zavrsavati zadati dizajn a ovaj postupa je dobar samo je za studente pocetnike koji uce SW.

[@AlexsEngineering]

Hello, thank you, maybe I will in another video, this was just to show you how can you make it :D

[@antoniosertic577]

Iz kakvih biblioteka ?

[@cyberdragon3889]

Hello! What at 7:54 CONVERT ENTITIES does? I would understand when is good to use it and when not! Thank you in advance, awesome lesson

[@AlexsEngineering]

I converted that edge there, because when you convert something is already fully defined, and i used that converted circle (wich has 12 mm in diameter) to make the rectangle, i used the circle as a reference for the rectangle,
So basically, you use convert entities command when you need something you already made in another sketch (in the same plane), because it comes already defined, I hope I helped you with this 🙂,

[@SlightMalfunction]

One thing that you can do to save time is to extrude only the first tooth, chamfer the two edges, then under Features, use Circular Pattern to pattern the extrusion and chamfer features.
Also, for the cut that squares the end of the axle, you can sketch just the square and skip the triangles. After that, when using the extruded cut, choose Direction: Blind, Distance: 16mm, and check "flip side to cut." That will cut everything OUTSIDE the sketch boundaries.

[@amadoundiayedia9119]

Hello
I like learning about you but please can you go slowly

[@AlexsEngineering]

Thank you, i will try 🤗

[@MR-ik4xv]

Thanks for the video
I have learnt a lot

[@AlexsEngineering]

You're welcome, I am happy to hear this 🤗

[@MiSTeRJoKe96]

amazing stuff alex, i like it, especially for the yellow choiche!

[@AlexsEngineering]

Thank you very much 😍