So how it works is, before you remove the OEM Rear bumper you need to place some painters tape underneath the Rear taillights on the Rear bumper and grab a pen or a pencil and draw the lines where the OEM Taillights are sitting. Then remove your stock Taillights and trim the bumper, also you'll see where there's a top screw on each side that holds the bumper behind the Trunk they will need to be trim to clear the fitment. I like my OEM lower Front bumper grille I'm keeping it, but I am relocating my Front License plate and installing an NRG tow hook strap. I'm gonna save up for the Carbon Fiber Hood and Carbon Rear Hatch, also the Carbon Fenders and Side skirts and I'm getting a high Mount Carbon wing. If anything my Interior will probably look like a show car and the Exterior like a Racecar.
Its been to long to remember, also sorry about the really late response, just didnt see it, but bearded panda fab on insta will do any dash piece in carbon or get a 4D wrap would be your best bets
I got this diffuser like two weeks ago and the fitment doesn't seem right lol Its straight and the oem one it curves, I don't know how you got it to fit I'm having 2nd thoughts about it, when you use those screws are they the ones with the nut in the other end ?
@@carsonharvey7188 I got one of the better examples so I didn’t have to do much, but sanding down high point/ anything that sticks out is your best bet, they should be relatively the same shape as the factory area. Just used self tappers to pull/ pin it to where it needed to be
Your headlights are hella sick !!
Thank you
So how it works is, before you remove the OEM Rear bumper you need to place some painters tape underneath the Rear taillights on the Rear bumper and grab a pen or a pencil and draw the lines where the OEM Taillights are sitting. Then remove your stock Taillights and trim the bumper, also you'll see where there's a top screw on each side that holds the bumper behind the Trunk they will need to be trim to clear the fitment. I like my OEM lower Front bumper grille I'm keeping it, but I am relocating my Front License plate and installing an NRG tow hook strap. I'm gonna save up for the Carbon Fiber Hood and Carbon Rear Hatch, also the Carbon Fenders and Side skirts and I'm getting a high Mount Carbon wing. If anything my Interior will probably look like a show car and the Exterior like a Racecar.
I’m saving for the carbon hatch, hood and fender but first a haltech ECU to run my built head
super late but do the 11-13 spec d's fight a 2015 scion tc??
anyway i can buy does headlights from somewhere?
Houston halos on insta
Where did you buy the carbon fiber stickers that go inside the dash?
Its been to long to remember, also sorry about the really late response, just didnt see it, but bearded panda fab on insta will do any dash piece in carbon or get a 4D wrap would be your best bets
Is this 2011?
2015
I got this diffuser like two weeks ago and the fitment doesn't seem right lol Its straight and the oem one it curves, I don't know how you got it to fit I'm having 2nd thoughts about it, when you use those screws are they the ones with the nut in the other end ?
Just some self tappers, most of these require body work but I just used the screws to hold areas where I needed them
How’d u get it to fit?
@@carsonharvey7188 I got one of the better examples so I didn’t have to do much, but sanding down high point/ anything that sticks out is your best bet, they should be relatively the same shape as the factory area. Just used self tappers to pull/ pin it to where it needed to be