Full Height Turnstile Installation - MairsTurnstile.com

The installation of the full-height turnstile is divided into several parts:
1. Confirming the solution.
2. line embedding.
3. assemble full height turnstile.
4. controller wiring connection.
For more details, please check our article:
mairsturnstile...
The previous preparation steps may be somewhat different due to different environments and sites. Please complete them according to your actual situation. This is the most important part about the specific installation and wiring of the full-height turnstile. If you purchased our full-height turnstile, you can fully refer to the installation and wiring in the following video. Of course, if you didn't buy our flap barrier turnstile, the process is similar, You can also refer to it. This part is roughly divided into five steps:
First of all, the inner surface of our full-height turnstiles will be packed with soft foam, and the outer surface is a hard wooden case. When you receive the goods, please first ensure that the outer packing wooden case of the products is free of any damage, and the information on the waybill is clear and complete. If the outer case is damaged, please make sure to take a video as proof, and write on the waybill that the outer case is damaged, and reject the goods, In this way, we can be sure that we will have to pay the corresponding cargo insurance compensation. When you disassemble the product and each part is intact, we can start the installation.
1. Assemble the product first, so as to determine the hole position, and then disassemble all parts of the full height gate.
1.After positioning the hole, drill the hole and embed the expansion bolt;
2.According to the turnstile wiring diagram, Connect the power line and ground wire according to the turnstile wiring diagram.
3.Turn on the power and test the normal operation of the full height turnstile.