⛐ Check out our Garage to see what tools we use and recommend: www.amazon.com/shop/worldmechanics ⛐ Subscribe and hit the notification bell by the subscribe button for new videos: th-cam.com/channels/J9xpq0qUZevSEdBSFqO2ow.html ⛐ Our GoFundme Page: www.gofundme.com/auto-repair-guys
I really need some help. I have a 2012 Dodge Journey SXT. It will start but won't idle. We got the miss fire code changed the O2 sensors, spark plugs & coils, crank sensors, & a new battery. We have no lights on dashboard but we push the gas pedal & it won't go past 3000 RPMs. Do we need to change the throttle control sensor? Please help & answer.
I have a battery symbol with a lightning bolt between to bars on my 2010 Dodge Journey 4 cylinder 2.4 I got a knew battery and altanator but I've been told it's what u showed any ideas...
So would this be a reason the rpm jumps a little even when I take my foot off the accelerator? I would even feel the car jumping a little bit too like it jumps when I try to get up to speed only on the freeway
How can I raise my engine idle speed? I need at least 700rpm to activate the voltage regulator in my aftermarket high output alternator 2015 Journey 3.6. Currently idles at 600 or lil less
I replaced mine but when I start it after about 1 second of starting it revs to 3 RPM and stays there until I shut it off. I hooked the scanner back up and says it’s the same thing even after rescanning… what do I do now
I had a code that said throttle pedal and switched it and it revealed up....I looked and no answer it was working fine so switched it anyway so when this happened I installed the older one and it worked fine so I'm guessing I got a bad one or a part for another car....I did notice that in the so called new one the connector didn't go all the way down no matter how much pressure I applied...so I don't know 😂😂 for now I'm driving with the old one cus it works
Hi have 2013 Journey crew had 2 replacement transmissions .Went into limp mode called shop who installled them.Said coil packs and plugs .Went into limp mode again code PO75A cleared it .So what would be my next step. Thanks
I love to watch your Video because it's very usefull, do you have special Channel for Dodge Journey 2.4L eapecially year 2013? Because most of dodge journey that sold in our country is with engine 2.4L 👍🏽
Warning: Dodge journey is a total POS. Battery behind driver side wheel. Fuel filter INSIDE of the Fuel pump now the Throttle position sensor is INSIDE of the gas pedal? Kill me.
Installed The gas pedal and now I start the car release the break and it goes wide-open throttle or at least 3/4 so I have no longer any gas pedal only brake release and apply has anybody else had this problem…?
I have a P2127 code right now. While I can still get gas to the engine, I don't think it will be long until it doesn't work anymore. I'm gonna try and do this. Thanks guys! Edit: Turned out to be my catalytic converter.
That’s POS dodge for you. Christ you’d think after all these decades they could figure out how to make a car that doesn’t suck. The Japanese are the only ones that make a decent car. Damn shame the “domestic” cars are all Chinese made now.
⛐ Check out our Garage to see what tools we use and recommend:
www.amazon.com/shop/worldmechanics
⛐ Subscribe and hit the notification bell by the subscribe button for new videos: th-cam.com/channels/J9xpq0qUZevSEdBSFqO2ow.html
⛐ Our GoFundme Page: www.gofundme.com/auto-repair-guys
Hello brother I had a question... can you put a v6 engine in a 2009 Dodge Journey with v4?
Does it neec to be calibrated aftet installation?
How often do you need to change the pedal on a 2018 Dodge Journey?
I really need some help. I have a 2012 Dodge Journey SXT. It will start but won't idle. We got the miss fire code changed the O2 sensors, spark plugs & coils, crank sensors, & a new battery. We have no lights on dashboard but we push the gas pedal & it won't go past 3000 RPMs. Do we need to change the throttle control sensor? Please help & answer.
I wish you did it with a 2011 and up Dodge Charger because it has 3 screws and 2 are hard to get to
Excellent help again
I have a battery symbol with a lightning bolt between to bars on my 2010 Dodge Journey 4 cylinder 2.4 I got a knew battery and altanator but I've been told it's what u showed any ideas...
It could be the throttle body
So would this be a reason the rpm jumps a little even when I take my foot off the accelerator? I would even feel the car jumping a little bit too like it jumps when I try to get up to speed only on the freeway
Why did you change the peddle, was there no rev or acceleration?
Can this sensor failing cause the car not to start?
How can I raise my engine idle speed? I need at least 700rpm to activate the voltage regulator in my aftermarket high output alternator 2015 Journey 3.6. Currently idles at 600 or lil less
What was the reason you’ve replaced the pedal?
Because the throttle position sensor is the gas pedal 😭
Electronic Throttle control. Low power and limp mode
hello i have a 2014 dodge avenger replace cylinder head gasket car start but will not throttle how to fix it
I have the same car and the same year. I got the same issue. June 16th 2021
Thanks. My 2007 Chrysler 300 2.7 threw check engine light and OBD2 P0123.
I have a 2010 dodge journey 3.5l rt, starts idols but no rev up from pressing the peddle, or acceleration? Changed peddle any ideas? Anyone?
I replaced mine but when I start it after about 1 second of starting it revs to 3 RPM and stays there until I shut it off. I hooked the scanner back up and says it’s the same thing even after rescanning… what do I do now
I had a code that said throttle pedal and switched it and it revealed up....I looked and no answer it was working fine so switched it anyway so when this happened I installed the older one and it worked fine so I'm guessing I got a bad one or a part for another car....I did notice that in the so called new one the connector didn't go all the way down no matter how much pressure I applied...so I don't know 😂😂 for now I'm driving with the old one cus it works
Hi have 2013 Journey crew had 2 replacement transmissions .Went into limp mode called shop who installled them.Said coil packs and plugs .Went into limp mode again code PO75A cleared it .So what would be my next step.
Thanks
I have code P0638 in a 2008 2.0L turbo diesel RHD help please
I love to watch your Video because it's very usefull, do you have special Channel for Dodge Journey 2.4L eapecially year 2013? Because most of dodge journey that sold in our country is with engine 2.4L 👍🏽
FREEMONT é a mesma coisa, nem precisa de canal específico
Why did you replace the APPS ?
Can a fuse cause this problem
I have no code or engine check light but my pedal sticks
Can this not make it start?
I have the lightning bolt on the dash and already replaced throttle body car will not start just cranks
Did you fix it?
@@josuemagallanes1923 can a 2015 2.4 dodge journey engine fit in a dodge 2012 dodge joutney ty
@@rikhiesingh9591 I believe so, with a few adjustments if needed
Josue Magallanes yes
@@brandonwarren5408 Mines was the fuel pump, didnt wanna turn on just cranked
Warning: Dodge journey is a total POS. Battery behind driver side wheel. Fuel filter INSIDE of the Fuel pump now the Throttle position sensor is INSIDE of the gas pedal? Kill me.
I stg on my mf life
I am finding this out slowly I am so upset every week something new I live in the north the battery us always draining due to the cold
Installed The gas pedal and now I start the car release the break and it goes wide-open throttle or at least 3/4 so I have no longer any gas pedal only brake release and apply has anybody else had this problem…?
How you fixed this problem I replaced my gas pedal but the rpms go high when I release the gas pedal
Did you ever fix this issue?
I have that issue too...
@@flaviolozoya you ever find the answer
You have to reprogram the computer. Can’t just replace the pedal.
I have a P2127 code right now. While I can still get gas to the engine, I don't think it will be long until it doesn't work anymore. I'm gonna try and do this. Thanks guys!
Edit: Turned out to be my catalytic converter.
Does the car start with this sensor not working???
Yep you can completely unplug it and it will start BUT "it will only idle".
@@Tay58382 can it caus stalling
Hi you do a great job. Thank you. please can you make a video for parking brake? how to change it? thanks a lot
What’s the code for this
PO123 is what came up in our 2016 R/T
I just replaced mine and now it won’t start
What in the this is tripping me out the freaking pedal itself you have got to be kidding me is that not the weardist thing I've ever seen
That’s POS dodge for you. Christ you’d think after all these decades they could figure out how to make a car that doesn’t suck. The Japanese are the only ones that make a decent car. Damn shame the “domestic” cars are all Chinese made now.
Emerson B many of the parts in this car are Japanese
@@toollookchannel actually they're Italian. Fiat Freemont is the other name for this vehicle in certain parts of the world
Unplug the battery first so your airbag isn't armed.
I have the lightning bolt on the dash and already replaced throttle body car will not start just cranks
What you do to fix it
@@ytafln2955 did u find a fix? i have a 2013 charger with codes p2127. p2122 which do show live data and p0222, p0123 which dont
@@Josue_S87 yes I had to replace my Gas pedal sensor
@@ytafln2955 thank you, going to pick up and install it tomorrow