Those sensors can be removed by unscrewing the metal plates the sensors are installed onto. Once removed, simply follow the wire to where it plugs into the circuit board and remove the plug. They're the multi-pins that plug into the right side and bottom right corner of the board. Good luck!
Replaced one of these today....went flawless after watching the video. Thanks!
Cansomeone post a link where i can order parts? Everytime i type something in the search bar it redirects me to usual manual 🥺
Thanks for the video. I will soon be doing the exact same thing and this will really help out in the field!
How can I bring that circuit board to the top so I could calibrate
Mine is stuck in the lower position and it won’t run up to the back side. And idea how to do this?
Make sure to watch the updated calibration video! This isn’t correct for some machines. Mine didn’t work at all until I recalibrated it correctly.
I need to replace the backrest wire harness for EC-618B. Is the process similar? Is there a video tutorial for that model chair?
Can i use 18v DC on the 2 prongs?
Yes, that will be fine
If 24v dc power not available how do I drive new mech into position after install?
At 4:37 you can see how to turn the motor by hand.
How to replace cz710 kneading sensor and 3D sensor?
Those sensors can be removed by unscrewing the metal plates the sensors are installed onto. Once removed, simply follow the wire to where it plugs into the circuit board and remove the plug. They're the multi-pins that plug into the right side and bottom right corner of the board. Good luck!
@@cozziatechnical8661 Thanks very much!