- 50
- 2 887
Renshi Craig
เข้าร่วมเมื่อ 15 ก.พ. 2010
วีดีโอ
Autocross: preparing your car
มุมมอง 31หลายเดือนก่อน
Here is my checklist: I think I forgot to mention in the video about checking your tire pressure. Very important, ya gotta check that. - [ ] (Cold) North face jacket - [ ] Mount for phone: track addict - [ ] White long sleeve shirt - [x] Air psi: 32 front 29 rear - [x] Clean windshield - [x] Food: pemmican - [x] Mounts and insta go3 - [x] (2) smart Water - [x] Radio: 90.1 - [x] Jumper cables - ...
Crown Vic aero testing
มุมมอง 36หลายเดือนก่อน
Finished testing the pressures along the top centerline of Serenity.
Shito Ryu Empi kata
มุมมอง 16หลายเดือนก่อน
I’ve been working on the timing of Empi, and I’m envisioning the down blocks as throws at the end of the sequence. Practitioners of Empi, any thoughts?
Shito Ryu: Seipai
มุมมอง 220หลายเดือนก่อน
Seipai kata as I understand it based on Kenwa Mabuni’s book: The Study of Seipai: The Secrets of Self-defense Karate Kenpo
Crown Vic aerodynamic testing part 1
มุมมอง 68หลายเดือนก่อน
Based on Julian Edger’s TH-cam videos and book: Vehicle Aerodynamics - Testing, Modification & Development. This test is done at front of the car on the Ford logo.
Crown vic final update for SS braided brake lines
มุมมอง 282 หลายเดือนก่อน
Crown vic final update for SS braided brake lines
Crown Vic aka Serenity front mid undertray failed
มุมมอง 8ปีที่แล้ว
Crown Vic aka Serenity front mid undertray failed
Good shit👍
Leave the keys in it ill pick it up here in a few days
No idea what you are talking about… why would I do that???
@@RenshiSerenity so I can steal it and smoke crack in it duh
Man that looks like such fun! I need to find an autocross event near me sometime. I miss tracking so bad. Also RIP those cones. Haha! We all push it a little too hard sometimes!
Definitely! I wish I had found autocross sooner. Ya got to go over the edge to find it 😉🤣🤣
Good to see you out there & thanks for the Sub!
Do you have to torque at ride hight ? And do you grease the rubber upon install
Yes, you will need to torque at ride height and grease. ADTR had good instructions.
I use 48”x96” FRP wall panel from Lowe’s. The only issue I had was hitting a cone while racing and it cracked. I’m now using ABS, but haven’t raced with it yet.
Are the FRP sheets treated or plain. Want to be I get the correct stuff
Video is appreciated!