วีดีโอ

Did you try to lock the doors with the hood open?

Como se solutions ese problema

I'm pretty sure that's an Aftermarket alarm, if you bought it used.

If the factory alarm goes off. Close the door, lock it and unlock it with the key. If that doesn’t work try starting it, if it starts.

Mine kept doing this what sucks is I have a loud siren, many suggested to me that could be fuses, relays or even my killswitches, turns out it was the blend door actuator, and keyless entry module. The door switch would click but wasn’t lock nor unlocking, I removed the door panel and saw the mechanism wasn’t connected, but left it as is, I have a habit of pressing the lock and unlock button on accident so i just have it where I can arm or disarm my alarm. If those don’t work for y’all try looking for any loose connections or even ripped wires. Also check your TBC, ignition fuses, ecm, bcm.

Mass sensor

What purpose does this shows with no answers

😅 gas is almost gone and on last block. Maybe running on fumes.

Your video sucks. Nobody cares about the extra bs we want short and too the point. Were not car shopping we’re trying to figure out an issue

What was the problem

Thanks for the non-instructions. Very helpful.

The High Mileage Ferrari is a little no worth money. Low Mileage Ferrari is worth money in the car market. My Ferrari 458 is low mileage.i tell your something. Ferrari 458 Startup is amazing sound and this is my dream car forever. And. I have one Ferrari 458 .but only drive in Holiday (mean country festival and any festival), travel one time in my country one time for long distance (but this is very good experience ).and as usual time i only drive 1 times one month in near my house area.other time is no drive or only startup(but not daily like only startup Ferrari 458 two weeks one times only) If u agree with my comment.please like .if not don't mad at me and don't criticize me . everyone's opinions is different and i respect everyone .Thank You.

Why do the bezels around the gauges look like WALL-E 's eyes

where is the lithg for the check engine

Do you still have it and are you Interested in selling it?

Man kind of was having the same problem but mine is the 4.3 vortec and when that was happening to me my MAP sensor was my problem

It’s the neutral safety switch on the transmission play with the shifter while turning the key or replace

Are they suppose to make a a slight wirring sound on start up then goes away after a minute ??

If you run 90’s out the side or shoot it straight back it’ll be louder otherwise all the gasses just shoot everywhere due to the flange

Maddison Mcadams keep car one like Jake keep bulldog for one day fake

I pulled the horn fuse and the horn relay in the engine bay fuse box. Fuck that alarm

How did you fix it

so i had the same issue with my 2004 gmc andypu can disable it by pushing the small button by the fuse box to disable it. the fuse box by the door

My truck doing this now what was the problem

Disconnect the alarm

I found out what fixed my issue with my high-beam indicator was not the grease which I tried didn't work I replaced the signal switch GM Genuine Parts D6299A Combination Switch which fixed the problem for me

What codes?

U don’t need a bew battery

I know it’s an old video but did you find out the problem ?? Need help pls! This is exactly what mine is doing

Hit the unlock button on the remote

I just had the same issue happen to me at a gas station. I didn’t know about this but I bet that’s what got me started too is when I got out and opened the door then got back in and closed it. She fired right up. I had thrown my jump pack on it thinking maybe a cell just popped in my battery, no go. Then I started to think maybe my starter just went but then she fired up like normal. This has to be a anti theft issue or a BCM issue or something along those lines.

Amigo esos sonidos de alarma o timbrados a la hora de encendido no los hace mi Silverado, quiero activarlos de nuevo pero no sé cómo si me pudieras ayudar te lo agradecería, en español por favor

No point in posting a vid with no answer or response 🤷🏻‍♂️

Disconnect the horn for now

Probably the IAC if it has one or throttle position sensor… it sounds like it’s running mechanically sound but you never know could be a cam or crank sensor

These things are nothing but TURDS. I had a 12 GMC Acadia Denali. Put me in the poor house. First the transmission at 53000 miles, then the timing chain at 83500. And all kinds of sensors in between those mileages. I'll never own another 3.6 again. Nothing but a nightmare. Timing chains done at the GM dealer was $3,700.00. Transmission (Wave Plate Failure) Rebuild w/ Labor $6000.00. POS. Anyone that wants one of these or even owns one, GOOD LUCK.

Did you fix it?

Revisa las tierras del auto, principalmente la que está debajo del múltiple de admisión y revisa si el alternador está mandando corriente como corresponde

Wtf did I just watch lol trash video

Well there is 2 minutes of my life I will never get back

I junk mine last week ......gotta love GM B.S. products

Having the same issue

What was wrong with it?

Also a problem with the ac actuator where it blows straight hot air out of nowhere but you can take off the vent and reset it

My rear doors squeak also. I lube them and it still squeaks. I have 156k.

Same year & color as mine. I have the LT.

Where the hell you live at that your finding these trucks so cheap. Sell me your truck.

R u fucken serious

Check your BCU, clean an reconnect each connection from ignition key , to starter relay into the BCU.

My car has same light off and hard to shift it bang sounds and shifts in the delearahip now..im expecting very expensive repairs..smh.car is 2012 tribeca 130k miles