วีดีโอ

Thanks for taking the time to do this vid.👍

How do you make the vehicle beep when both unlocking and locking? Ours only beeps on unlock.

Thank you.

Yesss! Finally ! I must have pressed every bloody button on the dash trying to change the time!! Well, except the set button. 😆😆😆

Rather than trying to use a flat blade to pull the remote out, push it through via the buttons at the front. Much easier.

Finally!

Darn, Didn’t work on my 2011 Kia Soul

Hi mate, just a quick question, my key fob on my 2005 territory takes a fair few presses sometimes before it locks or unlocks the car, iv also changed the battery to new one but it still does the same thing. Sometimes it works perfect but alot of the other times it takes alot of goes before it unlocks or locks, could it be the whole fob?

Wht if u dont have the original remote !!!

Much the same replacement procedure as my 2004 RTV Ford ute.

thank you...I was a bit worried about breaking something when prying apart so I just gave the other side of the joint a slight poke and it instantly came apart.

Could you talk a little lower? I could almost make out a couple of the words you said.

Gosh I love a YT video that gets straight to the point. Thanks!

Even after skipping through this my head hurts.no more please.

Thanks bud but I think you got my missing screw extra in your parts bag. I had one of the double ender screws missing, 3 needed only 2 supplied, so had to use a self tapper into the plastic clip. Looks the same but I know the truth and it really bugs me. Arrrrrrgh! 🤣

That was good ,Thankyou!

Thanks bud, gonna make it a quick install now.

Can you do a video on replacing the courtesy light on the ford territory

Can this apply for 2010 territory model as well?

Hi, helpful video. I was going to remove the whole throttle body as per the instructions on the SCA can and then clean it. I think I will just keep it on and spray , and hopefully not damage plate.

Good job mate appreciate the video, Just about to order the belts and do mine. Would have been nicer to watch it in landscape rather than portrait mode though.

Is it work in kia rio 2005 ?

Worked on a SZ 2011 TS Territory - With an original spare fob that hadn't had a battery change in a few years. Thanks!

What if i dont have an existing fob?

Awesome thanks

Dependiendo la temperatura tú compresor de aire accionará o parara

I had to refer to my own video today 😂😂😂

Was the oil plug gasket made of aluminium?

Good video - really helped me out.

Can you please do a automatic transmission service Transfer case service

Mazda littearlt the worst card

You saved my son over $200 ,thanks so much 2:30

Its invaluable for diyers, thabks

just bought a 2005 territory this video was very helpful

Tried this and ended up just de-programming my old remote 😅

I don't have a fob, only a key, and my unlock button inside the car is broken. I can't get the car to go into this programming mode for the life of me. I've even tried rolling the window down and activating the power locks by putting the key in the door and turning it to lock then unlock the car with the doors closed. Then pulling it out and flipping the ignition 20 times. Can't get it to let me program my new fob.

Good job mate my humble suggestion would be get yourself some Bendix blue ceramic brake lubricant, and just put some on the very end of the pads where the metal slides are and on the slide itself. Maybe even remove the slide pin and put straight silicon grease on that…. And when you press in the piston, all the black burnt brake fluid gets forced back up into the master cylinder, and I find that you don’t want that so you better off to crack the nipple at the caliper and get an assistant to pump the pedal and just bleed, the caliper until the fluids clean again the first bit of fluid on those fords will come out black as the ace of spades because it’s been cooked on account of being underbaked……. Only my suggestions, I’ve got a BA and it’s the same set up. But otherwise, it’s very satisfying to do these jobs for yourself ……..!! PS - and I found while you’re there for the sake of five bucks. Get yourself a stainless steel bleeder nipple from a brake parts supplier and swap it out with the steel one that comes standard on the car you’ll never have trouble with them, seizing and snapping off in the caliper…….

Cheers mate 👍🏽

Did you have to program the transponder chip with the new flip key aswell??

Really appreciate the video mate, I just changed mine. The AC belt was a bit of a struggle, I had to use one cable tie, two was too much.

Thank you for your video. It was exactly what I needed. 👌🏼👍🏼

Best video I’ve seen on this mate for a DIY. Cheers 🤝

Exact noise my territory has. Will anything change from spec or will territory throw a code over time if resonator is begone ? Its concerning that noise. Just makes the car sound like rubbish

Cheers for the help mate sadly i bought the wrong spark plug remover size and had to re install everything again lol

😊 Promo_SM

Hi , how can I program remote without OBD scan tool for Kia Picanto 2012 ? Any idea or tips?

Loved ur video bro

Just did mine today after watching this 👍

Thanks mate!

will this work on 2011