วีดีโอ

Ive changed all my sensors the computer not reading anything but lights still on?

Thank you for the video,it was very helpful. I was having trouble abs and Esp.thank you God bless you all.

Kinda bad enough dealing with rust issues lol and I'm a big dodge fan.started with a 1970 truck lol

Im dealing with the same issues was told to change my front bearings and sensors $1800 later same problems grr.

Good video. I have 4 wires from front actuator 2 are positive on 06 Dodge 1500 4+4. Even when switching to 4+4 then same 2 are positive. One is supposed to turn negative to switch on actuator. But doesn't. New actuator. Transfer case definitely kicking in. Continuity tested wires all the way to firewall. All good. Any suggestions please. I've spent every dime on truck and actuator. Any suggestions please. Im a carpenter but common sense. Help .

My lower is Bosh and turns on when you plug it in without pressing any buttons and won't turn off unless you unplug it ! It was left out in the rain....🙄

I have a problem, can start it but instrument cluster dont work.all lights are on. What could be the problem?

Donde vives tengo el mismo problema yo vivo en tx little elm tx

Really greatful for this vid, honest thank you!!

Did U confirm connector plug viability

Thank help me a lot and save me $$

My truck has the same lights on. 2011 dodge ram 1500.. there’s a wire hanging from the passenger back tire.. 4by4 don’t work also..

Thanks for your video. I have the same code ("NeutOf") on a John Deere 3320 eHydro. The code is still showing and the tractor doesn't crank even after using a jump wire in the harness and bypassing the switch as shown by you. Any suggestions about where to go from here?

Good morning, I have a problem with my 2006 Dodge Ram 1500 5.7 Hemi. The drives do not work and the ABS lights are on I replaced the sensor on the axle and the front ABS sensor that was indicated by the computer All drive lights are on on the counter and the N diode on the switch, i.e. neutral Has anyone had a similar problem

I have a model 401015 that wouldn't start again after I went inside for a moment. Sunny, hot-but-not-scorching day. Batteries fully charged. Blade motor grunts but doesn't start. The self-propel motor works fine. Any thoughts?

Stop talking and just fix the thing!

Having same issue I’ll never buy another Ram in my lifetime

Thanks this gives me a starting point Also what exhaust are you running

Good sir ! Thank you for the video, can’t believe a little rain would cause that. Geez!

Very informative. Will try this.

Very helpful

Damn bro you speak wayyy too slow You lost me

So had a similar issue on my rear driver side. I hard wired new connectors on the rear and I also had to bypass the connector all together on the front right. I ended up wiring new pins for the front right right into the abs module To fix this problem. Pins 27 and 28 are at the main module for the front right. My 2011 ram 1500 5.7 4x4 had green with yellow and blue with grey wires to the connector under the driver door for rear driver side. There is another wire that is blue with green stripe. Do not confuse them. If it wasnt for this video i probably wouldnt have found my shorts. 2 years and 5 mechsnics couldnt figure this out. Dodge recommended a whole new body harness to fix this problem and 2 days of labour for 2 service technicians!

Removed screws from handle, but the handle is not coming off.

I've been fighting with this same issue for 2 years. If this works I'm going to be so happy. I can finally offload this heap of junk and buy a Ford 😂😂😂

I had tires rotated and next day I get these same lights

This was rough

I got same problem on drivers side

Very helpful. Followed the steps, I fix my lawn mower. Thanks a lot

Thank you for sharing I have a 2011 with the same issue but the serv 4WD only turn on in the morning and it goes away during the day

I have the same issue but it is accompanied by a controller fault on the integrated brake controller module and it only really happens when I punch it on the highway and if I turn truck off it goes away and my cruise Controle didn't work no matter what any idea?

Love the video but I would rather let you fix it than me.....

Thanks for the info, I’ve changed all four sensors on my ‘10 ram and the same three lights still come on, but only intermittently, I’m now thinking I have a short or broken wire somewhere too and I don’t know which wheel because I don’t have a code reader like you, so I’ll have to find a place that can look it up for me, thanks again!

Why is his such a common issue in these? my 2012 has the same light display.

I have same problem left side

Thank you for taking the time to share this! I have the exact same issue.