วีดีโอ

Weight and mass are different. Don't mix them up. Otherwise excellent explanation. Thank you.

How did we take X/R for Source and Transformer?

Non sense

Can you provide the mentioned excel sheet? Thanks

Sir, Could u explain me how to calculate the corrected impedance voltage at rated current as shown in the above table. Thank u sir

Excellent how about thee zero sequence impedance calculation

Excellent.

Sir, Which make DC selection switch available in the market

Kindly share the PDF of all

please make video on various relays 50, 50N, 51, 51N and their settings. How are they selected for various applications. Is there is standard list? please clarify

sir, how did you take primary fault current as 1/4th of the secondary current. How did we get 1.09375 kA Please clarify

i was always looking forward to such a video. Great job. Thank you

Please make video also in hindi language

Sir i check 24 voltage DC our substation.i find out that positive to Earth 26voltag and earth to negitive zero potionia what is fault in system.

Thank you Sir I have question: Is there equation between time multiplier and operate time? What is time dial ? Thank you

How we select the tripping time for 300 to 350ms we have any standard or it is in some practice.

Sir Hindi me hone se accha hota

Nice sir ,carry forward distance protection in next video ❤

Very good. Thanks 👍

Great job

Great info. I have a question. If external ct ratio is 180/1 and external pt ratio is 22000/110, meter ct ratio is -/5 and pt ratio is -/110. Is it possible to have such connection? If yes, then what will be the multiplying factor in that case and if no, please share the reason why?

Great information. If two phases are reversed then it will be -E/3 right?

kon mi jmr

U ARE WRONG. if the measured voltage drop is 330v, how can be the %age voltage drop is 10%. Please answer

The results mentioned in table are according to which standard? Thanks

Power for all 3phases or single phase?

Sir very good video, thanks

R & Y phase will carry 54 A, how? R is shorted to earth. Will it be R & Y or Y & B? In your previous differential stability test video I(LV) = 93.31A. Please clarify....

Superb sir please tell me about as differential ct polarity

thank u sharing ..plz mention transformer vector group and rating , voltage ratio. suppose if trafo is DYn1 vector group then connection type 1&2 are in relay settings?

(330/33000)*100=1% not 10%

Which applications used reverse polarity CT's

This video available in Hindi

Very good explanation Thanks

Very good. Thanks 🙏

Sir I have doubt in star point side current can flow?

Why we need to short the HV and LV side, does it have effect on capacitance result?

Sir why p2 is connected to tra sformer side

Sir why we connect LV side P2 to P1? Normally current flow source(LV side of transformer)to load

Hindi langvej please

Video Hindi

Very nice sir..❤❤

Very good. Thanks 🙏🙏🙏🙏

Why required double DC supply or separate DC for CRP

Is Gokarna Substatiom

well done

Pls describe line differential relay

Nice , do a video for PT selection scheme for one and half breaker system

Helpful🎉

Thanks 🙏