วีดีโอ

Very good. Learned a lot.

Nice

When I go to test mode the humidifier on light flashes all the time, unit never kicks on

You don't show which direction the new filter goes. One side has two holes and the other side has a large opening.

Is there a rough flow rate that we would expect?

Can I replace the electric filter with a media filter instead?

Thanks! All of your videos are clear and complete and well produced. Helped me a lot with my Aprilaire 700 problems.

Your video skips the insertion (or verification) of the plastic screen filter into the new Solenoid.

Can I put a disposable air filter in this, if so does the button have to be on or off? I just moved into a new home and the button is on with a disposable filter. I went to remove it and shocked myself.

Thank you, great video!!

Great video! But I think it's also good to mention the plastic inlet strainer, and the sintered bronze filter that's in the inlet side of most solenoid valves. If either of these gets clogged with rust, or calcium and lime, the flow through the valve can be impeded and you will think the solenoid valve isn't operating.

@OnTimeMall thanks for sharing the info! In 3:00 you mentioned that if too much water going out of solenoid valve, it could overflow the pad and cause leakage. Is a very high water pressure going into the solenoid valve can also cause the leakage or the solenoid valve able to suppress the pressure? I have a SharkBite with a tap to control the water pressure.

You explained the procedure perfectly. Also, the video shots were clear and easy to follow. No wasted words; just a concise tutorial. Well done!

The air cleaner control was not working on my Aprilaire 5000 Model 501, I found one and replaced. It sill is not coming on. The blue light does come on, and was on before I replaced it. Any ideas on why the Air Cleaner Control is not coming on?

it always leaks.. no matter what you do or replace.. which is why hvac companies stopped installing these -- they always leak and fail

I noticed my frame has a pretty big amount of space at the top and it seems like water is splashing up and running down the access panel door and then leaking out and rusting the door screw. I pushed the frame up as high as it will go while still having the bottom connect into the drain. Fingers crossed because this is getting annoying. I also turned the water supply valve down (closed it a little) to try to slow the water pressure down

Thanks for the vid. Mine has been leaking out of the front door panel. Seems like water pressure is too high but it wasn’t too high when it was installed about 14 months ago. I change the pad 3 times per winter due to a lot of lime in the water. Even with a fresh pad it’s dripping out and the screw that holds the door on is all rusty. I’ve tried to turn the water pressure down. That helps a little but not all the way. Drain tubing is clear and free. So annoying!!!

Wow! Best instructional and trouble shooting video on TH-cam.

Watch the video several times. You either have an orifice that needs to be replaced because the hole in it is too large, a cracked feed tube, or the internals inside the cabinet are not assembled correctly. Pull the cover off and look inside, like in the video, to ensure it is correctly assembled and the feed tube is connected at the top. Most of the time, the problem is a cracked feed tube.

Great video, my 760 is leaking at the bottom. Sounds like it is probably allowing too much water through the orifice

My goodness…one of the best instructional videos on TH-cam! We recently purchased a home that has one of these but when we opened, there was nothing inside except for the two mesh pre-filters. How can we go about finding out what we need in order to benefit from having this unit? Thank you in advance!

Thank you for the detailed instructions. A friend of mine passed away and when I talked to his daughter she said she hadn’t changed the furnace filter. When I went over to look at it I found a Bryant electronic air cleaner. I had no idea what to do with it until I washed your video.

thx skibby

Simple and straightforward. Thank you

Saddle valves go against building codes, and will not pass home inspection. Insurance may not cover water damage caused by valve failure.

Saddle valves go against building codes, and will not pass home inspection. Insurance may not cover water damage caused by valve failure.

Does the rotating direction matter? Thanks.

Hi great video. My honeywell seems to only run water between 0 and 25‰ on the dial then it turns off. Did they install the humidistat correctly? I thought I should be able to turn it higher and hear the click/water turn on at my desired humidity?

Hello! I have an old Allied Products Division of Carrier Corp. Electronic Air Cleaner, similar to the one you have. I purchased my home in 2016 and all the inner cells and pre-filters were missing from the unit. The power was disconnected from the unit to the furnace , but I was able to get a few wires reconnected to see the power light did come back on. I was first considering buying a whole new updated unit, but if it was possible to track down replacement cells and prefilter parts, would you have any ideas where I could find these parts? The inside cover shows it as a Listed Electrostatic Air Cleaner 472H Model: 313X114100. Product: 313X114101 Serial# U751417. Other numbers listed 2-04602 H . If I don't see a response, I'll try the number you have listed. Thank You!

Where can I get the Manual Mode resistor for the AprilAire 700 or 700M?

Great video

Great video, thanks!

why didn't you just take the front cover off to access the solenoid wiring inside there?

Very good video - if you have an online store, you should put links to the parts in the transcript

Enviroaire whole house humidifier replacing the water pad

Which side does the air filter go on?

Thanks for your video. Helped out alot!

It sounds like it’s wired wrong. It should only get power when the furnace blower is running and the humidistat is calling for humidity at the same time

Air water purifier magnet jewellerly made electronic clean Ozone features fresh air so many uses multi use product

I messed with my unit for 2 hours trying to figure out why it wasn't turning on the water. The only thing I can figure is the humidistat is bad.

my unit is running even when the furnace is stop

Now show us how to hook up the outdoor sensor. 10,000 videos on the device but not how to install the temp sensor.

Great video - thank you!

What type of post filter is recommended

Thanks for this! I was researching how to get a new replacement inside cabinet part since all of the plastic clips were breaking off when I ran across this replacement option! Will be getting one asap!

A Challenge to wire correctly. JMO

What a great video. After watching hundreds of repair videos on a wide variety of topics, I think this is the best one I have ever seen. I now know what to look for in humidifier that is leaking water out the bottom.

Great video but most probably it’s a lime scale block- take the solenoid apart along with the top pipe and soak in vinegar for a few hours/ overnight. It will fix the issue. I think the power test is redundant. Stand near the humidifier and switch off the system, switch it back on at the highest humidity setting- if you hear a click- the solenoid is working if not, you know it has to be replaced.

great video. Thank you!! Question - if cells are still a bit damp, will light be off even if unit turned on?

For someone with the above setup, is MERV 11 appropriate or should we stick with MERV 8? Filtering smaller particles with MERV 11 is all good for air quality but if reduces air flow it may not be worth it.