วีดีโอ

Зато качение лучше и дальность хода увеличится 😂

Check if the axle of the wheel is tighten properly. Loosen axle could also cause this. If it's still shaking then it might be the motor could not controlled correctly. This can be caused by hall sensor error (inside the motor) or the motherboard.

What do you mean connected to the magnet? Hall sensor input on motherboard?

most likely if you encounter something like this, it is a Hall sensor error

How?

Apparently this thing caused by many factors. Could be from loosen allen bolt that holds the axle. Could be from bad hall sensors. Or could be mainboard issues. In my case it was mainboard issues. Replaced it and it works well now.

I believe mine is the motor hall sensor, atleast thats what the app said i made sure to unplug the power wire out before it burn my motherboard from over current

@@emaginthat169 yes. mine was showing motor hall sensor too in the app. but after checking the hall sensor it was working well. Apparently in my case, the reading from the hall sensors was not reaching the CPU in the mainboard. So I ended up replacing the whole mainboard to fix the issue.

@@erichps8124mine is the Allen bolt but when I took it apart to tighten it after putting it together it will turn on but won’t activate and on the app it says over current occasionally any idea how to get it to startup and stabilize

Thank you for that information. I have to admit that I possess little to no knowledge about bearings. Do you mind sharing with us why sealed bearings is better than shielded bearing for this euc? Is it able to provide more protection against dirt or other contaminants? Honestly, I used 6203zzcm zinc because that's the only 6203 that I could found in my local store and it said it had less friction. Nevertheless, to all viewers of this video, I'll leave the choice of bearings type to you. As long as it is 6203.

@@erichps8124 The sealed bearings are better because they are sealed from dirt and dust. Shielded bearing are not. What I find weird is how KingSong and others don't use a bearing retainer and oil seals on their main bearings as these things would make it possible for the bearing space to be grease packed like a wheel bearing on a car, motorcycle,trailer,bicycle... A 6203 bearing is just too small as well for this kind of weight. They could have easily used a 6304LL or 6305LL and that would have been much better. A 6203 is a very small bearing size used for light weight rotors in small motors.

Thank you i just ordered sealed bearings for my kingsong

​@@DumbThumbsFPV Thanks for the insight. Does the SKF 6203-2RSH work?

@@jeffreytong yes, they will. 2RS means double sided rubber sealed, H means for heavy duty

Congratulation, you've just completed one of most difficult tasks in the world

If you like to drive ur euc on muddy road like me, probably one or more component start to make some rust and produce that noise

Good look brother

Hi. Tutorial menggunakan RTOS pada CooCox sudah sangat lengkap dijelaskan di user guide CoOs. Nama filenya CooCoox CoOs User Guide. Kalau untuk PWM di Nuvoton singkatnya sebagai berikut : 1. Tentukan mau pakai pin GPIO yang mana (tentunya yang support PWM - lihat datasheet). 2. Enable PWM Clock 3.Pilih clock source yang akan digunakan untuk PWM 4.Kemudian setting prescalernya. Untuk project di video di atas, lebih lengkap bisa dilihat di bitbucket.org/erich_ps/meinpanzer Inisialisasi PWM ada di file InitEverything.c