- 108
- 200 166
Thanga The One
United States
เข้าร่วมเมื่อ 10 มิ.ย. 2012
Thanga The One
วีดีโอ
99 Jeep XJ removing and installing axle shaft, HUB & brakes
มุมมอง 5511 หลายเดือนก่อน
99 Jeep XJ removing and installing axle shaft, HUB & brakes
How to mount cabinet door hinges using Kreg jig
มุมมอง 198ปีที่แล้ว
How to mount cabinet door hinges using Kreg jig
Mistakes to avoid in tongue and groove mistakes to avoid in tongue and groove cabinet doors
มุมมอง 82ปีที่แล้ว
Mistakes to avoid in tongue and groove mistakes to avoid in tongue and groove cabinet doors
How to install pull out shelves for kitchen cabinets
มุมมอง 2Kปีที่แล้ว
How to install pull out shelves for kitchen cabinets
How to build slide out kitchen cabinets shelves
มุมมอง 1.4Kปีที่แล้ว
How to build slide out kitchen cabinets shelves
Removing soffit and drywall work (Part2)
มุมมอง 438ปีที่แล้ว
Removing soffit and drywall work (Part2)
Step out flashing solution for water damage behind vinyl siding
มุมมอง 232ปีที่แล้ว
Step out flashing solution for water damage behind vinyl siding
basement joist insulation with window foam
มุมมอง 93ปีที่แล้ว
basement joist insulation with window foam
Water dripping from vinyl siding after snow days?
มุมมอง 56ปีที่แล้ว
Water dripping from vinyl siding after snow days?
LG TV - 49LB5550 No display / flickering display fix
มุมมอง 1.6K3 ปีที่แล้ว
LG TV - 49LB5550 No display / flickering display fix
Jeep XJ transfer case fluid (Dexron iii)
มุมมอง 7963 ปีที่แล้ว
Jeep XJ transfer case fluid (Dexron iii)
How to adjust shackles height without car lift
มุมมอง 1K3 ปีที่แล้ว
How to adjust shackles height without car lift
place your tank in front of the exhaust and the heat from the exhaust will keep it warm.
Are lights and solar panel water proof ?
Yes, it is working good till now , even in winter snow, it worked 4 hours daily, in summer up to 8 hours
At 9:49... when you INSERTED your KEY into the QUICK CONNECT... you LOST me..... I couldn't QUIT LAUGHING!
Very nice work. This helped me!
Man I need help my lug 9 strip
Thanks for sharing
Have fun we-blace de odring
Can I use without installing the batteries?
No, this is low power DC, so you need the solar device and battery in it. You can also connect type c cable to solar device if you need to power on for more time.
Great idea 👍🏼👍🏼👍🏼
Nicely done!! It looks great
I bought the e80 and it wouldnt drop below 50% even tho I had it at a 45% target which meant it never turned off
On high humidity day, it takes more time to reach 50 % , but 45% is impossible for me too. But 50 is better compared to 60%. I use calcium chloride method in addition to control high humidity
Does it ever go below 50%
Good video. I wanted to add and clarify that no, the wheel being mounted further in on the left side (newer) setup is not a problem with alignment. That is actually the proper location for the wheel. On the earlier setup, the factory composite rotors had a very thin mounting surface. When Jeep updated the bearings and the rotors to the new design, the new cast rotors had a thicker face, and so they made the bearing more shallow to make up for it. So the wheel ends up in the exact same place on both stock applications. Using new cast rotors on the old bearings actually places the wheel further outward than stock. It also makes the hub pilot for the factory wheels very shallow. To me, the ideal option for anybody with these unit bearings is to choose the later model bearing and rotors to match. This maintains stock width and keeps stock wheels registered on the pilot the best.
brave man doing this barefoot
Thank you
Next level engineering right there
Nice man this helped me a ton thank you
Did it take you a couple days to charge up the battery?
Not really, it gave 6 to 7 hours in summer, in winter just 2 to 3 hours, I didn't recharge the battery
@@thangatheone904But the batteries are mandatory or optional?
Thanks for the info
Great info. Thanks.
Thank you for the incense smoke idea. I'm wondering why you didn't route the pipe through the sidewall, as that would have required just one hole in the wall!
2 reasons I didn't do through side wall 1) I didn't have a concrete 4.5 inch hole bit 2) I live in cold area so routing the pipe outdoor will create water condensation and some time ice block on top of the pipe and reduce the fan life.
I explained it in the video at 3.00 minutes
I Iike the ideas you have, for putting the boards under the tires to get more room underneath for the drain pan, and also using aluminum foil to guide the oil to the pan.
Great job!
Super
Dope tho
1 seams 2 I like that ur working with plywood I’m sure this is a great method for things like stage sets and things that are not scrutinized under detail however if something is going to be furniture I rlly don’t think plywood is even a good idea
The seams they're huge
my r6 was also like this. but no error code.... the EXUP close when high rpm and open when low rpm....... No error code but im going to fix it myself lol. i think that's bad for the bike performance
NOT proper handling of a rented U-Haul truck!! you didn't drop the whole load all at once to wreck the bed and suspension 😂
1) Board length - ( no of holes × diameter of holes) = total blank space 2) Total blank space / ( no of hole +1) = single space length 3) single space length + radius of hole -> first hole center 4) single space length + diameter od the hole -> second hole center
Thank you so much for the time and efforts👍 This is very valuable information. Greetings from Belgium !
I need to do this to my Colorado
If you want connect propane do you need buy special converter, or it's ready from the box to connect propane ??
It comes with the box if you buy eh model
Your tires are rubbing on your lower control arms. You can see the marks on your tires getting worse as you drive.
Thank you, I will check
Great tutorial.
Promo SM
previous owner did this to a jeep i just bought, stupid. wipe all the spray foam off the home depot shelf when u could buy a $40 rocker and fix it.
Thanks for this!😊
Thank you for this! I think you are the only video that actually shows what to do with the exposed wires after removing the soffits. 👏
I wish I had seen this before!
12” ???
You should only need to use the rear brake when trying to prevent wheelies
Great video. Very informative. I just got my xj a week ago. My lower coolant hose blew today. 24 year old jeep with 215k miles and now it blew? Crazy, so I went ahead and bought lower/upper hoses. Just in case the other seems to slice open aswell.
4.5 hours but did you power the house with it? Or just ran...
I powered my house, gas furnace, all lights, fridge. Mostly everything except washer and dryer
It definitely failed because of the low temperature inside the tank. As the gaseous propane in the tank is consumed, the liquid propane evaporates to take it's place, lowering the temperature. if the temperature gets too low, the pressure inside the tank will lower, and supply to the engine may become unstable. To solve this, you can either leave the tank close to the generator to be warmed up by the exhaust, or you can use a larger tank, which will have a larger surface area and absorb more heat from the environment. In propane fueled cars, the propane goes from the tank to the engine bay in liquid form, and the evaporation is actually done inside the regulator, which is heated by engine coolant. However, small engine regulators are not designed to receive propane in liquid form.
I truly like this "teacher ". However, when I tap "like", the system will not except a thumbs up.
save the world use a shovel and be done
Lol 2 batterys later did one pass
Hey what happens to the battery’s when they die
Right so many people don't realize how much worse it is to destroy or recycle everybody going to electric is going to cause our power grid to crash more then it is already and by buying this your just supporting the abusive little kids digging in the mines for lithium smh
He made a pathetic path!! Lol