วีดีโอ

I have frequent CRC leakage issues in hot weather never experienced with anything else. Do not store cans in your vehicle if it gets hot. The coating itself works well.

how d i get free car?

Video is too fast towards the end. am watchil correct level of oil fill but i can't see on the demonstration so is waste of time to watch 😮

These cars have problems with self adjustment as you reverse. So they end up relying on the front disc which then wear to fast.

My new tensioner won't slide in. Any tips?

beautiful

Bro u put WAY TO MUCH grease! U barley need a dot of it on the side of the tip (boot tip) the grease can actually cause a bad connection

Its a ford.

I can’t believe you buy a car sight unseen and then have to go straight to work!

Can u use fluid film first on rust part then put crc over fluud flim will that work for rusted part

hi thank you for the video, do you have a link or more info on the DRL LED you used?

Great fix to keep the car going. I would clean up the rest of the oil pan and paint with red oxide then topcoat it.

Great. Thank you for the video. Epoxy glue is amazing thing

Just the video i needed; thanks !!!!!!!!!!!

This car can be drive in Ontario? The steering if on the right side. This will be tough to register or will not be insurable?

@0:28 Depends on how good this deal is. The Toyota Estima might be the better deal, especially the 2.4l.

Powered tools are a bliss to use

Thanks!

I figured it out its a bad ground

Mines doing that same thing what the fix

Thank you for this video! I'm definitely going to attempt myself wish me Godspeed. Probably not going to be today though no definitely not going to be today but soon thanks again

Did the new sensor fix the issue?

Hi Can get Contact details of Custom broker

Its called an inhibitor, not rust converter or reverser.

A very helpful reminder video.Thanks 👍

How many quarts total if you remember?

LOL why would you be trying to get the filter off from the TOP? Scared to lay under the car?

Why is the Napa part number for the belt

Good video

Nice video paapa

Mine has 177,650 kilometres

THANK YOU SO MUCH , VERY CLEAR EXPLANATION..

It takes one gallon only?

Only 1 quart? And the book say. 80w90 but you used 75w. Is that ok? Want to do mine as well

How's the fuel consumption?

Fluid Film and CRC are not really comparable products. FF is quite a bit less expensive and easier/quicker to apply. This is because it is available in one and five gallon containers that can be used in a paint spray gun or any type of pressurized spray system. CRC is only available in problematic 10 oz spray cans. FF is the way to go if you own large or multiple vehicles. I personally use them both for differing applications. CRC really needs to come out with one and five gallon bulk containers…but then again that might make it totally unaffordable!

Yea something on it . Your gloves

great video you went more in depth here and showed what to do if its too low or how to test it out thanks!

I have the exact same issue on my low milage -98 LS400 Did u fix it yet?

Why not show which hoses go where

I think everyone who owns vehicles with this 1MZ-FE engine finds out the hard way about what happens when the oil filter is on way too tight and you've got no room to maneuver, along with a scalding hot exhaust manifold if you've run the engine recently. The solution: Ratchet wrench, extension (plugs into the) cap wrench. Once you're changing your own oil filters by hand, you won't need the cap wrench ever again unless you want to use it to tighten the oil filter, and honestly, you don't need to. It's all hands.

You can adjust them next time without taking the wheel off. There's a black rubber grommet behind the plate . You can remove it and get to the adjustment wheel.

how?🤔

turn the music down

Дякую, цікаво!

Дякую

Гарне,цікаве і повчальне відео.

Good work. Always learning something new. Will use the funnel and milk jug next time. I have been using Supertech Advanced Full Synthetic 5w30 and OEM 90915-20004 for a couple years now.

Like the video. I changed my fluid and mine started to shift hard 3rd to 4th. question, can the 2005 lexus rx300 bumper fit the earlier one's

Hey,how do I contact you?I am in Leduc.