- 21
- 126 909
Jeff Touschner
United States
เข้าร่วมเมื่อ 1 ธ.ค. 2011
I'm always looking at what I do on a daily basis and then try to figure out a way to optimize it. If I can save some money along the way great, if it just frees me up to do something else that's great also.
San Hima Rooftop Cargo Bag (VicOffRoad)
Need to carry a few extra things during your next trip, or just keep your stuff contained in a dry environment? Using a rooftop bag is simple and cost effective. Vicoffroad supplied this bag for my review. This San Hima bag has succeeded where my other bag had failed. Check the company at...
vicoffroad.com/collections/san-hima
vicoffroad_usa
th-cam.com/channels/3Y-Lus7eqbXkECHsP58H2Q.html
vicoffroad.com/collections/san-hima
vicoffroad_usa
th-cam.com/channels/3Y-Lus7eqbXkECHsP58H2Q.html
มุมมอง: 686
วีดีโอ
MaxxHaul roof rack basket review
มุมมอง 13K3 ปีที่แล้ว
I installed the MaxxHaul basket with some modifications that were recommended from other reviewers. MaxxHaul roof rack basket - www.amzn.com/B073G49NPV Heat Shrink Tubing w/glue - www.amzn.com/B07CVYH99R Spray paint - www.amzn.com/B08MWX3P3X J-B Weld - www.amzn.com/B00YNJ2XAE
Grill Heat Shields, Heat Tents replacements.
มุมมอง 1.7K4 ปีที่แล้ว
2" x 2" x .25" angle iron cut to length 14.375". I was so surprised how inexpensive my total cost was, $14!
Stenner Chlorine Pump for Above Ground Pool
มุมมอง 6794 ปีที่แล้ว
The timer housing part # does not match the actual switch, the guts are interchangeable and I swapped out the original timer for this 3-circuit switch. Tank - Stenner Gray 7.5 Gallon Tank STS7GC www.stennerpumpparts.com/stenner-chemical-storage-tanks/stenner-gray-7-5-gallon-series-tank-for-45-85-series-pumps-sts7gc Pump - Stenner Fixed Output Low Pressure 45MP2 www.stennerpumpparts.com/stenner-...
Thanks for the video, I was sitting thinking how I could use up my old coffee filters to make small filters for Kcup filter, you solved it! Thanks.
Bravo. True genius.
Wrong wrong wrong. Stok has a video on how to do this.. th-cam.com/video/FlwUV_TqcZw/w-d-xo.htmlsi=n8eK4yorBEtz7U8Y Same as converting to natural gas so much easier than removing whole side and back. Sat in a walker and did this.
Very observant, definitely a different process. They’re different because my igniter’s are connected with a screw to the front plate, as I mentioned. Your video shows the igniter is connected directly to the tube. I’m glad you had an easier time then I did.
Good idea
Woww🎉 luv this!!
2 years after, hows your basket rack? Any noise or rust issues?
No problems, everything I did held up great.
🤯
Thanks
Do you know the distance between the cross bars from center to center? I want to add the basket to my crossbars, but they are fixed and do no adjust forward/backwards. Thanks!
Thank you ❤ Kim
【p】【r】【o】【m】【o】【s】【m】 😌
Hi Jeff. Thanks for this. I got the sides shelves off and the front control panel disconnected. How do you disconnect the igniter wirers from the control panel?
They should just pull off from the back side of the push button igniter. They might be stiff so just wiggle a bit to break the bond.
@@jtousch1 Thank you.
Thanks for the video. Was one can of paint enough for the whole thing?
I don’t remember if I used 1 or 2 cans. I did take a few days doing the painting on the weld joints
@@jtousch1 thanks for quick response! I wanna point out that same paint is sold in quarts, for $22, and can be painted using brush or roller. That would probably allow for two or more coats and leave some for future.
Thanks for keeping my blonde hair from turning green!!
So, I'm a little late to the game, but hoping someone will still see my question...the tube that delivers the fuel- how do you put it back/secure it/where exactly does it go? Started way too long ago & don't remember😖😖😖
Best, detailed video on this subject - THANK YOU!
Great job, tnx for the tips.
Worry about the rust? Galvanized it lol
Did you cover up the logo on the window factor?
I just painted over the logo on the wind deflector.
Who needs logo bro! lol
What size heat shrink did you use? It’s not allowing me to click the link in the description.
It's 1 inch Adhesive Heat Shrink Tubing, no particular brand
Is that an antenna?
No, because of the added drag of the rack I had to add the fin to help stabilize the air flow coming over the top. Doesn’t really help but my radio works better now!
Is it only ornament(decoration), or does it serve a function? Thanks
Funny question.
I believe it is for the antennae, correct? Thanks
Yes, it’s the antenna, nicknamed a shark fin by some.
Great video, had 1 question, noticed have a small looks like tail fin on roof. What is that called like to get one, Liked and subscribed. Thanks
That is the antenna for the car
thanks for the heat shrink tip, looks like it would prevent rusting of the screws and easily replaceable if damage. 👍
Best invention Jeff! And liquid chlorine stayed so cheap this year (even though the pucks were pricey)
One year update: This has been a perfect clear, crystal clean pool summer with this chlorine pump!! Ever underestimate the power of a steady supply of chlorine daily especially when away traveling.
Looks great! I can’t wait to travel!
That is very dangerous proud of you
I like your video on the replacement of the burners. I do have a question...I have a stok Quattro myself and was trying to replace my burners. I got so far but am having problems removing the front panel where the knobs are. How do you remove that part of the process? Looking forward to your response or video. Thanks
I meant knobs*
Once the side tray screws are removed I don’t remember having an issue. Disconnect the igniters, gas port tube and I think that’s it.
Okay so I'm not crazy. People keep telling me that filters will make my coffee stronger but I saw that it stopped me from putting enough coffee in the cup which causes the coffee to be weaker. I'm not making my own filters though. 😂
Your videos are great!
My grease trap and flame covers completely fell apart today. Looks like yours might need replacing as well. Any chance they covers those?
Travis Dunlap those parts aren’t covered by a warranty. I replaced my grease cup myself and made another video about flame covers with my solution. “Grill Heat Shields, Heat Tents replacements.”
Actually it's a very cute little filter and a penny a piece ain't bad but I just cut the coffee filters in quarters and push one piece down into the pod. There'a a little trick to it but it works pretty good.
Rodney, how did you make four filters per big filter?
I didn't notice this cabin having water. Did I miss it?
You didn’t miss it, there isn’t a water supply in the cabin. The bathrooms have running water, depending on the season.
The bathrooms are super close, a few feet away.
Maybe add the brand of grill for ppl searching? Is it Stok ?
Joni Touschner , this should work for any brand of grill. Your specific length could be different but otherwise it’s a universal solution. FYI... there are tags used in the background during searches that help guide traffic to more accurate results.
Cool 😎
I ordered some on amazon n they r short whats the number on the burner
I don't know the exact part number for the tubes. I got mine replaced under warranty. I was given the following information and numbers to call. I would recommend calling and see what they can do for you. Available replacement or extra parts for STOK grills can be ordered-purchased through the master parts distributor Gardner, Inc. at 1-800-848-8946. The STOK warranty process is handled through the STOK customer service phone staff at 1-800-847-5993, Monday through Friday between 8:00 a.m. and 8:00 p.m. EST, and Saturday and Sunday between 9:00 AM and 4:00 PM EST.
Got mine from Amazon as well. It has a "check model" button. Also, this is waaay too much disassembly. I literally pulled my tubes out and in. No prob. Just need to snake the wires thru underneath. ... Just fyi
What other chemicals do you use in pool?
Baking Soda (PH +) and Muriatic Acid (PH -). Cyanuric acid to stabilize the chlorine and Twenty Mule Team Borax to stabilize alkalinity and as a pH buffer. Reference the BBB Method online and check out www.troublefreepool.com/blog/pool-school/
Can you explain the benefits that liquid chlorine has vs. using chlorine pucks? People ask me but I forget the chemistry.
The No. 1 benefit, for me, is liquid chlorine doesn't have Cyanuric acid (CYA) in it. Chlorine pucks use CYA as a stabilizer in them, which just happens to be what turns hair green and also brittle. No.2 is cost and availability of liquid chlorine. I currently pay $12.99 for 12% 5 gallon carboys. No. 3 is ease of use, especially with an automated system.
@@jtousch1 and now , summer 2021, there’s a shortage of chlorine pucks/ tablets but liquid chlorine is not in shortage!
No green hair!
Those aren't dividers they're too allow fuel to flow and balance between tubes. They do serve a purpose
I thought the manifold delivered fuel and the crimped end of the burner tube I mentioned held the burner tubes in place. I need to replace my covers over the tubes, you have any recommendations?
Jeff, thanks for walking through this. Saved me a lot of time!
Glad it could help you!
Smart! It's cheaper that way.
The only heat is the wood stove by the looks of it
Bob Saget , that would be correct. You can order wood to be delivered, or bring your own.
That’s my BMW 328i, you should add a photo of the car 💛🔥
“Our “
More about the cabin: the beds are six feet in the air, not much floor space, plastic covered mattresses. Also at park: the one pool was closed and the large pool was freezing cold. There’s several other options there: bigger cabins, hotel, the motel had campfire area too. I won’t be in this cabin again.
Excellent idea even 6 years later. I have modified your process to this: First, I followed your instructions for the first filter. Second, I took that and laid it out on a piece of box cardboard, traced that out with a marking pen and, carefully, cut out the cardboard circle with a SHARP utility knife. Third, using this as a firm template, took a week's supply of filters (WALMART), centered them together and placed the cardboard template in the center and and traced out a circle on the top one. Removed the cardboard template and, using a sharp, new pair of scissors, cut out the week's supply of filters all at once. Then, I followed the remainder of your instructions. Thank you for this inspiration.
The cabins were built in the 30s. Rustic.
Thanks for the money saving idea! Now I don't have to spend $7-8 on k cup filters
that's a great idea, I need something like that to help save my back when shoveling