วีดีโอ

And how the antena works now ?

where did you buy the correct replacement parts? thanks

Excellent video. Exactly what I was looking for. I knew it that it was possible to fix that gap in the trigger. I had the M4000S and the M8000S also called the RX20TAC. and I like how low noise these rifles are, those suppressors really work, but the trigger is one of the worst that I had ever tried. I try adjusting the screw in the trigger, left of right and that doesn't do anything. It makes absolutely sense what you are showing, thanks for showing the dia. of the bearing. I will try on both, the M4000S it's the same mechanism. Thank you !!!!

Thank you!!! I would have never known how to lower the spare tire! On the side of the Interstate at night with cars and Tractor Trailers zooming by… Made short work out of changing my flat tire! 😅

All these videos r fucking useless how do u open the door to get the piece of shit actuator out if the door won't unlock in the first place.

Thanks! 😊👍🏻

Works a dream! Thank you a ton.

26 American minutes or real minutes ?😂

Thanks for not showing the hardest part😂

Where can i buy this kit for removing spare tire?

Hi, Im doing this on my a 2024 Dmax first time doing so, Just wondereing what type/size of screws used to fix it to the tow bar ?

Would acetone ( nail polish remover ) work on baked on decals ?

Where do you get the new stickers?

I just did this to my Stoeger S8000 E Tac and boy what a difference! The trigger is great now. Perfect fit with a 5x8x2.5 bearing. Thanks for posting this mod!

What was the guage thing you put in?

Well done mate, I know it's a little late. I just got a Prado 2013 with burnt on stickers. Thanks I will be doing the same.

Question after it’s hooked up in the radio, I ran all the wires to the back drilled a small hole place the camera in over license plate the little wire to the camera I plugged into the harness then there’s a yellow plug-in cable I hooked up the reverse to the reverse light on the back of the car with the ground separate of course then up by the yellow connection is it extra red wire? I just taped it off not sure where that goes but my issue is I manually have to put the camera on through the radio receiver for the back up camera to work so I’m thinking it’s something to do with that red wire just not sure, hope you understand what I’m asking. Thank you.

Stuck on the side of a busy bridge at night. I’m pretty sure this video saved me and my friends life because I just bought the car and the tire exploded on us and we needed to use the spare. There were people swerving and going 65+ mph, it was scary. THANK YOU 🫡

How would one locate what one is playing up

But sir when i am using back camera than sound of music remain and this how will stop plz help

Kill that Music Mate!!!!!!! It's Terrible!

Good video except for the background music…,

Waste of time. You see one fastener done that's enough. I thought this video was going to show all the different plastic clips on the car. I didn't need to see him do the same clip over and over.

What was wrong with them? What did you try to fix? What is on the board you replaced? Mine pair up but no sound when on wireless. With cables I do have sound

Hallo! iwiil find a shop!

hallo i need this! Ihave the standart X20! I will find a shop!

I bought one of these two years ago for $10 here in Oz and it's been a good machine but the switch for the wand died. I always had to use a bit of force to turn it to wand mode but I looked inside and found that when you turn the knob it forced a button on the switch to go more sideways than down so I just used a razor to shave off some of the plastic to reduce the angle and bingo. Thanks for the video.

Since your receiver did not have an end cap on it, I wonder that you didn't punch it through from the back end instead of crawling about under the truck ?

any wiring to hook up the usb port in the surround?

Front driver side door wont open fron the inside or outside even when unlocked.

Beware the cheap Chinesium crap copies all over eBay, they last a year and break.

I need to replace the other PCB, just donc see how to remove it without breaking it omg

My rear door wont open from the inside or out could you give some info how to fix this problem its a 2006 VZ .

What's the part called to replace the audio speaker?

Muy buen video. Tengo una kia Sportage año 1995 NAFTA 2.0 y yo mismo le hago los cambios de aceite, uso Shell 20w50 y filtro Mann. Pero no sabía hacer lo del engrase. Te consulto: hay que sacar alguna tuerca antes de engrasar? Qué clase y marca de grasa se coloca? Cada cuantos kilometros hay que engrasar? Muchas gracias! Un saludo desde Argentina!

my door wont lock as the button wont lock when pushing button on key, does that mean its the actuator?

Great tutorial and amazing result from this mod. Can I ask you, what difference does it make to remove the spring and pin? I didn't remove it as I was afraid the trigger wouldn't return properly if I did.

i recomend dropping the music. its way too loud, wanted to hear how loud the operation of the rifle was.

Handy video but needs light.

Fantastic job and great music 👌🏆 you have now inspired my confidence so a big thanks from Perth Australia 🦘😀

Shite music, why???

Rock Music

Bad Ass Music! Who's the band and what's the song's name?

What is that interesting looking distributor in 3 different pieces? Is that a special mod better for timing or something? Thanks!

G'day I just installed my DMX1025BT with my reverse camera, anyone have any idea how to setup the guidelines? If i go into the setup it says no signal (because not in reverse to power it up I assume) But when I go into reverse the reverse camera comes up and I cant get into any menus to go into guideline setup?

I have one of these and I never shoot it because it might have the worst trigger in any gun ever! Is there a difference in trigger “feel” between the two sizes of bearings or why did you chose one size over the other? Thanks for any help! Rolf

Wonderful nice n tidy car no oil leakage , well kept

hello, link please 😉

I have that air one ,is not accurate

You got a video on how to install the DMX1025BT itself? Having trouble with the directions and can’t find a video anywhere