วีดีโอ

Did this job penetrate? You should have shown us

You use 3.2 6013 electrode with amps of 90, for penetration?😢, thats not possible. Besides why didn't you show us your penetration for 2G.

Bang ìnofo tempat kursus bagi pemula🙏

Song?

Probably no penetration

NICE WELDING ❤

Show 😅

As un pase de raíz con 6011 a 97 amp de ahí tira el 7018 y me lo agradecerás✨ánimo

Amazing video brother keep it up but kindley upload shorts video ❤

if i stretched my puddles for that long it would look like swiss cheese

No tips just showing wire feed welding a fillet weld with circle type malipulation.

Turn your volts up for fucks sake. Cold as!!!!!

Man you doing good, I've ran miles of that. God bless and work safe.

Agun welldar ❤😊

অনেক সুন্দর হয়েছে ধন্যবাদ

Kindly brother make short videos 🙏

Fail

Nice looking welds! Very consistent bead pattern! I would be interested to see a cut out and etch to see what the penetration looks like. I don’t weld on thicker material like that so I generally weld hot and fast on short runs.

Top

It looks like the heat input slightly changes between the 2 feeding techniques.

😂😂😂130

Good job ! What brand 6013 are you using ? Ive ran lincoln, hobart, selectrode and radnor. The selectrode with brown flux acts like a 6013/6011 hybrid

頂端沒補滿 應該要做完美一點

Подварочный шов, ну и что, орден дать? У меня стаж сварщика 38лет.,могу показать как я шнурки на ботинках завязываю.

❤❤❤❤❤

A nás učili, že se sváří od spodu nahoru

wrong mask

Too much heat/ too low wire speed.

Real nice welds

❤❤❤❤❤❤❤❤❤🎉🎉🎉

👍👍

❤❤❤

😮😮😮

😮

Quisiera que esplicara con más detalles sobre la soldadura , y además en Español

Dcep or DCEN?

saya bisa mengelas karena 6 bulan ini melihat akun ini

Turn the current up to 110 slow the weave hold the sides forget the middle and practice until it’s becomes boring then do it all again welding is a self taught skill and you never stop refining that skill

2G position very good job

Weld face would be more consistent if he had a slower weave

FYI, that is NOT a 1G weld. It is a 2F weld. G = Groove and F = Fillet.

Udaya👍👍🙋🙋

Udaya👍👍🙋🙋

❤

What is the gap?

❤❤❤❤❤❤❤

A defect is locked, it needs to be corrected with a large one so that there is no slag left.

Prova saldare da sinistra verso destra.

Good job bro🎉🎉

Sir upload pipe line welding