- 1
- 16 941
Jojeil
เข้าร่วมเมื่อ 9 มี.ค. 2021
SOUTHWIRE RG6 Quad Shield Coax Cable using IDEAL F-Connector and IDEAL Compression Tool
In this video I'll show you how to terminate SOUTHWIRE or any RG6 Quad Shield Coax Cable so that you can make your own custom length wires. I'll be using IDEAL Fast + Simple RG6 Compression F-Connectors along with the IDEAL Adjustable F/BNC/RCA Compression tool. Support this new channel by subscribing and by liking the video. I hope you learn a few things and check out the channel for more videos.
Products used:
IDEAL Fast + Simple RG-6/6 Quad Compression F-Connector: amzn.to/30OL5hP
IDEAL Linear X3 Adjustable F/BNC/RCA Compression Tool: amzn.to/2OTyqYg
SOUTHWIRE RG6 CATV 18AWG Quad Shield: amzn.to/38DKlAF
Cable Matters 5 Pack RG6 Coaxial Keystone Jack Insert: amzn.to/3s0cc5T
Cable Matters 10-Pack Wall Plate with 2-Port Keystone Jack: amzn.to/3vqdlp5
Low Voltage Mounting Bracket 1 Gang: amzn.to/3bOof0p
Optional
Stripping tool for Coax Cable: amzn.to/2OnTDdh
Products used:
IDEAL Fast + Simple RG-6/6 Quad Compression F-Connector: amzn.to/30OL5hP
IDEAL Linear X3 Adjustable F/BNC/RCA Compression Tool: amzn.to/2OTyqYg
SOUTHWIRE RG6 CATV 18AWG Quad Shield: amzn.to/38DKlAF
Cable Matters 5 Pack RG6 Coaxial Keystone Jack Insert: amzn.to/3s0cc5T
Cable Matters 10-Pack Wall Plate with 2-Port Keystone Jack: amzn.to/3vqdlp5
Low Voltage Mounting Bracket 1 Gang: amzn.to/3bOof0p
Optional
Stripping tool for Coax Cable: amzn.to/2OnTDdh
มุมมอง: 16 946
Demonstration NOT OSHA APPROVED
Que desastre 😂😂🤦🤦🤦
I tried installing an Ideal Universal RG-6 compression connector (part #92-651 onto Tappan RG-6Q using the techniques from several videos and I could not get the results you got. Cutting back to expose 1/4 inch of the dielectric isn't enough. I couldn't get the connector onto regular RG-6 either. The dielectric just won't go flush no matter how much force I use. These compression connectors are expensive and I end up wasting them.
Why not spend the $10 on a coax stripper?
I suppose it would better pull screen wires back to obtain better contact with the connector.
Kids, don't do this at home lol
Thanks to your video I got 9 stitches in my thumb!!!
n00b
😂😂
put the darn cable on the table and cut it before you cut your finger!!!!
Very dangerous using that blade like that... there's a more safer way.
I was waiting for that blade to slip! Glad it didn't.
You did this incorrectly
The existing cable in my house is pretty damn hard to pull. Do I just keep pulling until it comes lose?
🤬🤬🤬🤬🤬🤬
Could’ve done this tutorial in 3 mins .. too long
And it’s wrong