วีดีโอ

Thanks dear. Keep watching 👍

👍

Keep watching 👍

Thanks, keep watching

Yes dear

You can use OPR Relay. Watch video of OPR relay, th-cam.com/video/FnOv93ZmsvQ/w-d-xo.htmlfeature=shared

Thanks for watching dear, for calculation kindly check the example again in video for small correction.

👍Keep watching

👍

Thanks keep watching

No, short circuit current

How may I help you

How may I help you

I tried my level best

Thanks dear, keep watching 💓

That's why I explained this in very simple mannar.

You must have basic knowledge

This formula is based on IEC 60364 Standard

?

MTO Hassan

Ohm's Law states that voltage is directly proportional to current, with resistance as the constant. The formula is V = I × R

Ohm's Law states that voltage is directly proportional to current, with resistance as the constant. The formula is V = I × R

Dear what is the size of drive and what are your motor parameters?

This formula is based on the IEC 60364 standard.

Thanks keep watching ❤️

Thanks, here is the next part th-cam.com/video/f4VTRn5f_-A/w-d-xo.htmlfeature=shared

Thanks

Thanks

For LED lights installations, the earthing conductor size depends on the total current and fault current requirements. Here are some general guidelines: 1. For LED installations up to 10A: - 1.5mm² (14 AWG) earthing conductor is usually sufficient 2. For LED installations between 10A-20A: - 2.5mm² (12 AWG) earthing conductor is recommended 3. For LED installations above 20A: - 4mm² (10 AWG) or larger earthing conductor may be required However, it's essential to consider the following factors: - Total LED current - Fault current (if applicable) - Distance between LED drivers and earthing point - Soil resistivity (if earthing electrodes are used) - Local electrical codes and regulations

Thanks keep watching ❤️

Sure

Thanks for the suggestion, sure 😊

❤️

Dear it depends upon many factors.

❤️

Both can be use but the size calculation will be different as described in video kindly watch again ❤️

No dear, the battery is old and the path is not short circuited because of coil

Thanks

Keep watching

So nice of you

My pleasure

❤️

Types of prd ?

This is the part of job

Thanks dear

You can disable start prehibit function by long pressing status key in programming mode then go to in input and output function then move to start prehibit function and just make all bits 00000 then press enter.

Wrong connection

Dear it was due to wrong star Delta connection

Is the casing earthed? Is it two or three phase power? You should give more info when asking for help.