วีดีโอ

Just sending two tops to specific spots with two different techniques.

Just sending the dangerous rotten fir snag to its final resting place.

Went up to Etna, CA to fall some trees to get recertification for my falling cert. The wind was blowing about 25mph as I got to the top of the tree from an approaching snow storm. The next morning woke up to a foot of snow on the ground and headed out to teach CPR and First Aid to 40 Timber Fallers. It was a great short trip up!

Haven’t missed a CrossFit Open since the beginning. 15 years of doing these workouts and the Open always get you a bit pumped up.

Removed some leaning Firs over a cabin, trimmed some Redwoods, and removed a Bay over power. All straight forward and a great day besides my GoPro cutting out randomly.

Took out a few fir trees that were leaning towards a cabin, and a few leaning towards power lines. Limbed up a few Redwoods and took out a small Bay tree over the service drop to the cabin. Was a straight forward job and all went as planned except when my GoPro would randomly shut off!

Used a rigging line to a pulley block to my truck to make sure the hollow core Oak fell onto the wood pile. If the center wasn’t comprised I could have cut it and just taped some wedges to send it over, but was easy to just leave a bigger hinge and just pull it over.

I had this heavy leaning Douglas Fir tree I had to take down and needed to fit it into a pretty tight spot. The fence was taken down and I had to try and fit it in between the fence posts even though the lean was directly towards one of the fence posts. Gunned it a heavy to the right to compensate for this and then bore cut it to prevent a possible barber chair situation because of the massive ...

Day 1 took down a Tan Oak that was dying after topping it and sending the stem back against it’s downhill lean with a counter pull and some wedges. Day 2 took out a multi trunk Canyon Oak over my buddies house and was was busy I forgot to film most of it.

Took down this Bay tree with a rotten top that was leaning over the hunting cabin. Took the new multiple tops out, the rotten top filled with dirt, and then did several negative block rigging trunk sections. I finished by pulling the stem over with a change of direction block to a tractor to pull the heavy leaner over right on target.

Two different Bay tree jobs removing the trees over propane tanks. I have my daughter helping me one one job and she has turned into a great helper when she is home from college. The last one had a bunch of small 5 gallon propane tanks under the tree all piped together to run the house.

Taking out the Eucalyptus cluster

Bay Tree take down

Flopping the dead Alder

Dropping tops Again

Pine tree removal

Water Fall Fir Removal

Dropping Doug Fir stick

Sudden wind storm redwood top

Doug Fir removal with a great view

Monkey Beaver Speed line kit in action

Falling more burnt hazard trees

Oak over the house

Falling Big Burnt Timber

Ants in your pants

Crispy Leaning Dead Tan Oak

Dead Doug Fir removals

Dead Tan Oak Removal with an amazing view

Triple top dead Fir field goal