วีดีโอ

😂师傅，没这么复杂，我修过很多法国车，基本上日本车，欧洲车和韩国车都有个别的逻辑，只是大部分人不懂法国车的逻辑，所以觉得脑残，搞懂逻辑后会发觉其实也蛮好修的，而且引擎很轻，取出来时很简单，另外机油，如果选择可以保护timing belt 的机油会更好，他新的引擎在我看过的涡轮引擎里都算很牛逼了，当然之前有款引擎很烂，pure tech 是真心强大😂

我看保养记录，还有一个柴油过滤器也要更换吧

Thanks. Great video. Real life: in the dark!

噴光油時出現非常多一點點是什麼地方出問題？

A je avto v karanteni zaradi okužbe?

Thank you

what diameter threaded rod and washer?

Do you know where the tailgate emergency latch is? I can't find it!

perfect video, thanks a lot!

Thanks for this video, I wasn't sure how to do it, now I feel like an expert!

❤❤❤❤

这种钥匙🔑的设计实在差强人意😢

Great video! The clearest one on here for this job. Just changed pads on a 2019 A7 👌🏻 (no need to remove those front bolts though, actually recommended to leave them on)

It's a pain so watch how much the audi electrical installation engineers suck and make our work soooo much harder

Great video. Helped me out. Many thanks to you sir. 👍🏻

I'm from India thanks

Where to buy the new replacement window regulator set for citroen berlingo 1

怎么重新设定换油里程和时间都没说呀！

Excellent job. I did it from underneath without removing the ignition mounting bolts. Very tricky as when I removed the switch all 5 bits fell onto the floor. The wheel and pivot. A small pin and spring and a plastic slider. Used a bit of grease to keep the parts in place. Works fine now.

幸亏我没有直接从淘宝买灯，感谢您的介绍，老兄。

Poland?

Hi To remove the glass I use this hole in the door, right?

Hello, when my vehicle is cold, the temperature indicator rises to 90° without starting the vehicle. Can you help with this issue? Thanks already for your help.

great vidio please do more on audi a8 thanks

Shift engineers VW worst silly design

真的腦殘😂

Do you know how to remove shift knob?

Thank you! Your video helped us a lot to replace a glass on this car

原來歐洲車的axle nut是內六角的

Good 👍

赞！学到了！才知道轮胎是没有内胆的！

Very clear, thanks your video

Did the computer have to be scanned?

Wait did he take the plane shuttle to Poland?

C4 Picassos in China are you freaking serious I see on my Google and they did not exist in China

THANK YOU. Your video is excellent!! Helped get 95% of the panel off. That cable though is a banana when not knowing how to remove it. That plier clip tool puller is almost mandatory. I bought a trim removal kit that had one, and I did use it successfully, there are 6 post clip towers, 3 on on each side of the vertical edges of panel. I bought a bag of 30 replacements just in case, and did replace all 6 anyway as insurance against new noises. Then I had to pull side to side while lifting to release the panel from the top lip edge. I had a lot of little tree seeds behind the panel at that area. That cable clip is not so bad, after knowing how to disconnect it! There is a small pull tab that needs to be lightly bent away from the attachment point and the entire cable assembly will teeter out by lifting. It's actually easy, but could not see what was happening in the last part of the video. I am refoaming the speaker seal, and placing flet strips at ALL contact points on my door where the panel will go back on. I have a temperature related chip-squeak annoying me for many years in the Spring and Fall when the weather changes.

Man do you know you spray WD 40 on that fucked up disc that you didn't change?

What year is this Q7? My front and rear brake calipers don't have the brake pads guide hardware like that? This is probably 4M model no way it's 4L

Я ничего не понял. Как стеклоподьемник то собрать и засунуть в дверь?

不可以只换灯管吗？

Thank you Very much... been looking for wheel disasembly... 😊

😊Thank you. Respect!

Thank you for posting this. I’m helping my father replace the regulator in his Iveko RV because the metal wire broke. We were able to use this video as a reference for replacing it.

Verry helpful thank you man🤗

😊😊😊😊

Thank you!

Best video on Q7 4M brake pad replacement on TH-cam 👏👏👏

Thank for the video even though i dont understand mandarin but it helps

Thank you,just what I was looking for

Good video thank you