วีดีโอ

🔥🔥🔥

Hi, I need your help with a complete u140f transmission overhauling kit with pistons or drums. Which site or where can I go to buy a genuine one. I live in St. Lucia in the Caribbean. If you can help I would appreciate it. Thanks

Can’t hear you with the music thank you for everything

Good day Sir question? Can a 03-70ls be mated with a G16B engine?😊

Thanks

Researching my 2003 E53 No Reverse issue. This is a great video!

Nice video brother I have a 03-72 l 2nd gear long shift 3/4 gear engine have to rev high for 3rd to work 4th don't work ooh and the ATM light is on all the time ooh and I watching from st.vincent w.i

great video. thanks

send me your number

Very informative

I have 1zz gearbox no reverse and I changed the back plate clutches its no reverse

What’s your number want to get in touch with you

What’s your number

I need one of does for a audi

Awesome Video

Nice view of this transmission I have a 2002 Nissan Sentra and 5 years ago was repaired by a transmission shop now the transmission was not engaging properly to drive when it got hot this happen when put in neutral or reverse or parking ,reverse works fine when the transmission cools down I can drive all day until is put out of drive I notice that if I put L1 helps to engage drive quicker than in (D) , I change the oil new filter and put a oil cooler and it helped a lot but is back with the same issue I was looking at the transmission repair manual trying to figure out what i can do to fix the transmission. Any help is appreciated thank 🙏🏾🤗

Question I just service my k111 cvt transmission was driving before reversing also the valve body also service put back together it going into drive with delay and no reverse it not even shake when put in reverse

Would’ve been nice if you didn’t have the background noise so we can understand what you’re saying

I have a transmission like that. It have to warm up like 20minutes before it start moving . What could the problem?

Hi mate. Got a problem with 6hp26. Gear 5 incorrect ratio and gear 6 incorrect ratio. 4th gear is ok. I have pulled the mechatronic unit out and tested the eclutch with compressed air and you can still hear the clutch engaging but it doesn't hold air at all. Does this mean the stator bush is worn?

What do you use to clean the valve body

I have a 2011 Tiida with a p0868 code which says the fluid pressure is low. Car is extremely lazy to move from a stop and doesn't want to drive up hills. Issue sounds similar to this ad wagon. Is it the same issue and fix?

Hello excellent Please keep your camera horizontal

Hello excellent Please keep your camera horizontal

i have p0971 error code, do u know how many ohms must have the solenoid?

Ping

nice

Thanks for the videos man very knowledgeable 👍

Do you have a link to the transfer solenoid or a trustworthy website?

Night blessings. Love your videos.my mother inlaw have an Suzuki grand vitara and i diy the transmission all Clutch was bad and rubber seals drive ok untill you going over steep hill it start to slow down. Would appreciate your assistance. Thanks inadvance

Good video but that bearing is for the secondary pulley, the primary bearing is the one near the filter

I did that to my pump. Not taken it off yet to assess the damage 😔

My bmw x5 30.i can't go backwards

They managed to solve their problem?

Hey Jones, y hope you can help me , m'y english is not so good, y i am from France y live at border with Spain with mountains and neurological issue so y need automatic, Y have à GM540LE on my 530d e39 bmw, 340000km. Y flush it every 60.000km, y have two post lift and everything, y clean the hydraulic part to, so that is not an issue. The problem that y have is at speed 90km/h (60miles) the rpm is at +/- 1500, When y accelerate à little the rpm goes to 2000 , y feel an vibration and it go back to 1500 , when y drive on highway at 130km/h the rpm is at 2200, there is no issue, all the other speed to, Its only at 90 with 1500/1700 rpm, Y think it is the torque converter, maybe the solenoid from the 5th gear ? What do you think ? Thank you !!

I have same gear, ist to 2nd shift is fine, there is no shift from 2nd to 3rd and 4th, what might be faulty?

Hi mate where buy all parts from ?

Blessed

Bless up bro i put new clutch in my grand vitara and not getting any reverse. 0372ls transmission

Nice work bad bro, yuh have a Instagram or sumn mi can shoot you a message pon?..have a 2007 335i weh a gi mi a 4f83..dida gi mi a 4f8f ratio monitoring gear 3-4 at first and dat gone..but have the 4f83 ratio monitoring clutch c right now..mi ina di states and work pon mi own car but diss a happen now..wi can talk bad bro 💯..reach out please

Nice job where can I get the masters kit to buy

good job but other than watching you place the ball valves back in, you fail to make sure to show us the exact location where all the ball valve go, so i had to find another video with more clear instruction

Excellent Job Mr. Jones

Respect mi g

Hi, It could be good if you could tell me for the part no of this barring (Is it DG358816, KOYO Japan ?). Thank you very much in advance.

What is the part number and where to get it from. Also is 6hp21x different than 6hp21 ???

how can i contact you

Give us the problem why make funny vedio like rhis ?

i thought code 4f81 was the A clutch

Nice work.