วีดีโอ

No issues with the scanner at all. I highly recommend you do not use recreate software. Contact these guys and please let them know I sent you. I don't get anything at all from it. Just want them to know I appreciate all the help they have me. dezignworks.com/

This reply is a little late but.....It picked up the table because the table isn't flat. When scanning you normally would scan/probe the table, set an offset for the scanner to ignore anything below the offset, and then start scanning. This was a quick demo in a conference room on a crooked table. You'll notice it only picked up part of the table. His offset wasn't high enough to account for the tilt of the table on the carpet.

I'm just glad the only thing that needed replacement were the axle shafts. Easy fix that didn't cost all that much when compared to all the other "repair/upgrades."

Feeling is mutual. Aside from that, Merry Christmas!

Just gave it, it's second oil change. 10,200 miles so far. They're trying to say it's because I put big tires and a lift on it. Problem with that is if I had bought the lift through the dealer they don't do anything to the steering components at all. So how's that different?

It's the far end of TRO. Past the point where TRO meets the park road. It was the first time I'd ever gone that far on TRO.

Thanks, I have not done that one yet. I want to do it next time there. I recognized the others, just not this one, now I know why.

It's about 40 minute drive. It's at Hidden Falls Adventure Park. It's where we go wheeling in the jeep.