วีดีโอ

about 16g

You can, but it will be difficult to fly. 85 fly much better.

@alex_k21 and 65 pro can on motor 25000kv

no

Use dji neo with mobile phone))

I bought antennas on AliExpress. It's "Lollipop 4" without branding. You also can buy well known antennas from Foxeer. I have 2 on my Cobra X goggles

buy separately the frame, motors, analog camera, VTX and flight controller for analog camera. Then assemble it. If you already have HD version of drone, then you need camera and VTX, and flight controller with analog OSD.

@@alex_k21 ah , thanks

I installed Happymodel EX1102 KV 13500 motors on this drone. Excellent motors!!!

I made holes in the canopy and screwed the camera mount. The wires are soldered to +5/GND on the flight controller.

yes

Glad you enjoyed it!

I successfully sold the cetus x kit and bought a new Skyzone Cobra X goggles. The Meteor 85 is much better for me

se ve que son unas llolipop

You can buy any 5.8G Lollipop RHCP antenna on a long stem and a corresponding connector. I have "Lollipop 4 mini" and "foxeer Lollipop 4 plus on my Cobra X goggles"

you need to solder the wires to the controller to the +/- 5V pads.

I flashed the controller with firmware for Cetux X with ELRS 3. All settings remained original. The drone is well controlled. With the camera it wobbles a little at low speed, if you fly fast it flies smoothly. BetaFPV 450mAh 4.2V batteries. Now BetaFPV has better batteries for 4.35V (HV). On new batteries the drone flew for about 5 minutes in Air mode. Now the batteries are more than 1 year old, they still fly for about 3 minutes. VTX power is always 25mW, I do not fly far. Skyzone Cobra X glasses catch the signal perfectly.

Hello! "5.8G Lollipop 4 mini RHCP" from AliExpress

Камера пристегнута к канопе пластиковыми стяжками. Питание от контроллера 5в, можно припаять либо рядом с TX/RX или рядом с бузером, если не нужен он. Схему контроллера можно найти на сайте BetaFPV

@@alex_k21 Спасибо

Да, отличные батки. Долго живут. BetaFPV 450 2S уже 1.5 года и до сих пор летают 5-6 минут. GN3 HV на 550mAh быстро сносились за полгода и уже долго не держат

Kraków

easy

To avoid overheating, you need to fly immediately after turning on) and the top of the conopa can be a couple of holes to better cool the drone. In betaflight confirator you can configure PID mod for VTX, and it will be at zero power until the arm is turned on.

Ого!!!! Сейчас гляну) Спасибо!

yes, there are several free contact pads with +5V and ground

Not possible since I don't have this drone anymore.

The camera mount was included with the Runcam Thumb Pro camera. Attach the camera mount using zip ties to the canopy of the drone.

For 5 volt power there are several places on the flight controller where you can solder a wire. (I have a connector soldered so that I can easily connect the wire from the camera). The camera mount was included with the Runcam Thumb Pro camera. Attach the camera mount using zip ties to the canopy of the drone.

If you practice well in the real world and not in a simulator, then there should be no problems with control

By plastic ties

BetaFPV F4 1S 12A AIO Brushless Flight Controller 2022, SPI ELRS 2.4

@@alex_k21 Thanks !

Lollipop 4 RHCP from AliExpress

Lollipop 4 RHCP from AliExpress

Lollipop 4 RHCP from AliExpress

Thanks a lot!

Yes

@@alex_k21 When I flew it I thought the drone flew like a hot bag of garbage apparently I’m the one that flies like a hot bag of garbage.Im gonna go cry now.

@@para9111 womp womp

Hi! I didn't have issues with ELRS connection. My Radiomaster Zorro was connected with meteor through betaflight configurator, when it was with Elrs v2. Now my Zorro has elrs v3 and I use it only with CineLog 25. For my old tinywoops I use Betafpv LightRadio3

To put it into bind mode, you need to remove and reconnect power 3 times.

meteor 85, I think, will be better, because cetus x video transmitter is poorly cooled and at maximum power it will most likely quickly overheat

Hello! It depends on power setting. I don't fly far so can't say the maximum range. Usually I set 400mW and fly around with range not more then 300 meters.

btw beta fpv's vtxs are not that good not as bad as some others but not that good. you will not get a lot on any of their's

Yes. For me, Meteor 85 is definitely better than Cetus X.

4-6 minutes

Good weather) Hot and dry. Humid in Batumi and fresh in Borjomi.

@@alex_k21 ok thanks 👍

Hi! I think insta go2 will be too heavy for meteor75. Even if the drone takes off, it will be too difficult to control it. Meteor 85 will be better for insta go. But better runcam thumb pro, it weighs only 16-17 grams

@@alex_k21 Probably.

Hello! It is a stock canopy, the camera in the mount from the kit with the camera, the mount is attached to the canopy on plastic ties from the supermarket

Hi! I have a controller from cetus X with elrs 2.8, I just connected the drone to my computer and in the betaflight program pressed the Bind button, on the controller also the Bind button.

@@alex_k21 thx

Awesome! Thank you!