วีดีโอ

Its too loud bro!

Sir can i replace 450v 100uf capacitor with 500v 47uf capacitor in 135w 19.5v 6.92a laptop charger

Mine charger pwm ic got burnet how to replace it 33 watt vivi charger

When I check my laptop adapter output is good but when I connect with my laptop that time charger is not accept lode

By link

Amplifier se connect krte hi humming araha ha, baki sab thik ha, problem kaha ha batao, laptop ka adapter ha...!😊

Please what do yyou mean by not connection capacitor backwards

DOES IT HAVE AUTOMATIC CUT ON AND OFF FOR CHARGIN?

Esa karne se Bhai kuchh video me bol rahe the ki 1-2 month bad battery battery ful jayega kya esa ho sakta hai esi phone ka experience bata do 😢😢

Sir Mera samsung np350v5c Laptop ka Power adapter hain..... GH - 19v - B Wo abhi Laptop chala to leta hain par ... Cirkit main ek parts blast hua hain. Cirkit main Interference supration Capacitor k bad jo (Mov) parts hain ....Wo Blast ho geya ...( Abhi Konsa value ka Mov Replace karu ) Please Help Me 🙏

My adapter has an IC with six legs,not the same(its so tiny that specifications dont even exist),what do I do in this case,how shall I detect the resistor to pull out??..Nice video and work by the way..thank you in advance

Laptop charger ko plough me dalte hi house ki mcb trip ho rahi hai or house ki light off ho rahi hai kya fault hai ?

❤

does this module have short circuit protection and reverse circuit protection?

My buck converter is always in current mode( red led is on). Why?? It has red and green leds, but only red led is on. Can you help in solving my issue.

Brother, the charger of my Asus Tough gaming laptop is not generating voltage at the output

Bahi ham pakistan ma rahtay hain aur hamaray payri zuban urdu hay agar urdu ma bataday day to kuch ham bhi sekh latay

Current draw is limited by the sink or target, that implies even if we give 100Amp to a LED that can take only 10amp, the led will take only that 10Amps! (Voltage is a different story though) Current is decided by target/sink and once the sink's maximum current is reached, it would stop taking any higher current like the Ammeter in this test shown In a way we cannot overdrive current beyond what the sink can take, sink pulls current it can take, we cannot 'push' current into sink (if I may say in terms of mechanical motion)

170w lenova adopter voltae 19.5 or 20 shows immediately drop 1.

Good زبردست

Ampier loss 😢 so only voltage

Please make trigger for 20v output

sir I have a 19-volt 3amp laptop adopter my problem is when I give load on adopter voltage, it automatically gets 0 volts

Contact number

Should I place a diode so as to no reverse current flow from battery when power is off ?

Bhai kya mera phone bhi Aisa kar doge

Sir I have a 24 volt 3 amo power supply and want to charge a 12v 7ah battery, as you suggest to set the limit voltage and current but after full charge is it necessary to remove battery from charging connector, I mean will it be automatically cut off charging after fully charged because i want to engage it to my mini home ups to charge the battery?

Why did you choose resisters in series and left other

i am getting 18v output which should be 19v acer laptop charger.indicator light on charger is ok..but laptop is not taking power..after long rest again charger works.. there is small burnt in circuirt board below main capacitor but not in any green part of PCB and any other components. any solution?

Bhai Hindi Me Banao Na English Mai Video Banake Kisko Sikhaoge Foreigner ko ..

Good work 👏

Can you tell me please if i connect this open charger to laptop what will happen

Tujhe English Mai bolne keliye kon bole bewre

Amp test this board any problem in this board

Nice❤❤❤❤❤😊

Nice. But it's only showing voltage, cant drive much load with it.

Sarkat

Im wondering your are too smart or too stupid

Thanks I enjoyed let me subscribe it was amazing ❤❤

Don't do this at home - this isn't safe at all = the cell can easy explode - VERY DUMB VIDEO AND NOT A GOOD ADVICE !

After wasting more than 3 minutes of my life on watching this BS, I realized why i didn't need to know this at all. Why the heck are you posting this shit?

Waste of time. Even worse that you made us watch you turning screws.

What an useless video.

Ridiculous. Those power supplies burn out if you draw more than the small current rating. You can buy a very cheap soldering iron, and do a proper job. Time-wasting video!

Yes, I want my time back, the wires weren't welded, they wouldn't pull apart because they were twisted, that lead got hot, didn't it. Well at least YOU learned something