วีดีโอ

Well done! I found this helpful towards a 2019 cls 400d. I noticed the heater wire for the windscreen on the passenger side was not plugged in. Is that normal?

Mask is an were so stupid.... If you can smell a fart!! Lmao wearing it then how's it stop covid 😅

Hey obed nice work just wondering what kind of caulking glow you use it’s very expensive and what kind of paint you use I saw you use the paint on the windshield. What is the name of it?

Nice my question is @obeds auto glass repair did you recalibrated this

Porque podría crujir un parabrisas después del cambio,me realizaron un cambio y suenan como plásticos en la parte inferior derecha del parabrisas?

Do you have a video on replacing the rear windshield, my local glass figment centre messed up mine, the brackets on the sides are not lining up properly, about a 1cm raise compared to original

This was a great install. Everything done properly. Not all glass shops follow proper instructions like this video so make sure to go to someone that has a good reputation. Also request manufacturer glass. It is held to much higher quality standards.

WAIT a fking sawzall?

That knife thing doesnt scratch the paint?

I know this video is a couple years old, but I was wondering, how do you keep from having the adhesive material squeeze out and become noticeable around the sides of the windshield? I have had a shop do it twice and both times they have made a mess. Am I being too picky, or should it be clean?

Great work man! Ive replaced three my self on older cars, brock one glass...rrr my brother did. Was going to do my wifes Rad4 but to many tools these days!! And there's some skill involved of course...Oh well leave it to the Pros instead. Very interesting to wach any way, Thanks for taking the time, ❤

Amazing video. Thank you .

Hi. Nice vid. Do these require calibration after installation? Thanks

Will you make more videos ?

Bro very professional good work, just I want to point out little thing if you gonna add in your video it’s helps a lot for viewers like you have to talk and told about every step which you missed that some places either one very professional work! Thanks

This dude is a beast man! Fast and excellent! ❤

Finally a video that shows a windshield with the heating cord. Trying to figure out why my replacement windshield has heating elements but does not seem to heat.

I got wind noise on mine

Hi I just had the windshield replaced on my toyota kluger 2021 but i noticed that both the top corners the glass is rounded not the normal pointy edge that would sit in the corner. Is that normal if not original glass replaced wouldn’t it leak later on?

What were the black and red cord your unplugged?

The molding on each side of windshield looks so easy to snap in. I accidentally pulled the top part out, and I am not able to get it back in. What could be wrong??

What are the 2 small parts in the windhsield? One is the camera but the other one?

What's the windshield part number?

Thanks for the video! I just had my windshield replaced and didn't remember there being a "huge" gap between the glass and the a pillars. Sure enough, there is. I just never inspected the original windshield.

Good job taking care of this vehicle. I would go to you if I could. Can you tell me why you do the bottom urethane alone on the car but other 3 sides on the glass? Isn't there a risk of leaks this way if bottom doesn't connect to sides well without bubbles? I had someone do mine but they were not as careful. They broke off the clips that go in on either side of that large plastic bag that sits underneath the glass where the wipers attach. The clip on either end is broken off. Is there a way to fix that with something else or is leaving them out ok? Or where can you buy replacements? Also, they were not as careful removing the plastic side panels on each side and it seems they are now not seated in properly. I can see some of the white clips. Is there a way to get more of those white clips? The ones where there was 5 on each side panel. I saw them rip those panels off instead of slowly removing them like you demonstrate. Good job, and keep going. Thanks for the video. I may try to remove panel pieces myself to see if I can repair them or replace them. Is there somewhere you can buy replacements if needed? Thanks!

Lol moms car broke

I have a separation due to degeneration of the rubber at the bottom of the glass and makes water getting in the car, What is my solution? new calking or new rubber gasket?

Brother, what is this tool called?

Do you have a 2015 video

Brill Video! Can I ask how much did it cost to replace the windscreen?

Thanks for posting! My 2019 Honda Civic needs a windshield replacement, so now I know what to expect.

For the tools they using good job. But that cut out tool is so outdated, I was using that in 1986. Uk so far advanced in removal of screens is unbelievable.

Thank you for the information. I am going to start my own business next week. This helps alot.

My 2017 Honda Civic needs this right now

How much does this cost?

Good job! 👍🏻

Is It xle model

This is Pro Auto Glass in missaguga Canada I worked there as installer back in 2019 it's a good place tho

I think...will never be the same these car. ..dont use the floor as a table

What were those things in the beginning he popped off on top of the windshield wipers screws called?

Shoot the bead on the glass!

The 2017 Highlander had a large Toyota Safety Sense module on the windshield below the mirror, this must have been a 2016 or earlier Highlander.

Do you recommend OEM replacement or aftermarket? Any differences in calibration?

Awesome

They didn't recalibrate the windshield camera..??

Patient approach 💐

I was discouraged in the business because of new glass and need to calibrate now windshield replacement business have to know how to calibrate new vehicles

Gracias. Saludos desde Panamá

No paint protection… why?

Hi bro am Evans for Ghana 🇬🇭 am also into this work I mean this is what I do in Ghana 🇬🇭 good good job 👍