วีดีโอ

äventyr

safety?

A 15 Tesla-rated magnet, which quenched at 14.7T, was commissioned. A quench is defined as the abrupt loss of superconductivity. This loss occurred just before the filming began, and there is still some time before initiating the liquid gas phase transition, as the helium needs to warm up from 2.4 Kelvin to 4 Kelvin.

After a full charge cycle it should go solid green but mine just blinks amber and green. Why?! FW 2.5.1 MFG 13/10 - 17

Merkel Helix .308

Dual start threaded part for a stereotaxis frame in for service. They sure managed to bend this part good. :(

The oil is this stiff at 18c.

This is a MP-101 that I picked up at a used machinery dealer about a year ago and that I now in this video show a final inspection of. Setting the thimble to 0' and tightening and loosening the blade I'm getting a consistency of about /- 0.01mm or just a bit more as the setup is a bit crude. So over the 200mm measured this amounts to 10-20 seconds error and as the thimble is graduated in minute...

One of the good things coming out of China these days

Made a short video for ChrisB257 showing a old brake design.

Sharpening instruments in the Jungner T&C grinder

Sorry for the delay, hope this helps.

Tunghållare

Lathe chuck : 50 gram out of balance

Tip for drilling hardened steel 58-60HRC

You can't have too many vices!

Enlarging a part on the DECKEL copy mill

DIY machinery leveling feet

Part one

Metal shaper project: spindle housing

Just a short update on the deckel copy mill

More way surfaces

Way surfaces

Bent hand wheel :(

More Värnamo metal shaper fun!

More tool and cutter rebuild

Tool and cutter grinder rebuild

Makeing chips in the Värnamo metal shaper again

On the topic of useage counters