- 40
- 77 697
Shane Hicks
United States
เข้าร่วมเมื่อ 7 ก.ย. 2013
My channel I post videos of me working on my equipment and working
splitting firewood before a snow storm
Splitting a load of firewood by hand before a snow storm in Kansas City mo
มุมมอง: 2 441
วีดีโอ
Cutting down brush with a stihl ms 660
มุมมอง 3518 ปีที่แล้ว
Cutting down a trailer load of brush with a stihl ms 660 Chainsaw with a 36 inch bar
Plating a trailer frame
มุมมอง 48K8 ปีที่แล้ว
I was welding the plate on the trailer frame that was shortened
Ford f350 cold start with bad glowplugs
มุมมอง 10K9 ปีที่แล้ว
Ford f350 cold start with bad glowplugs
Much quicker than a rake! Good job
@@MikeCressey-ko9zd I don't use a rake unless I haft to
its fine
Have you tried soaking your electrodes in water?
Or just use a rebar Bender cutter
3406B or 60 series or NT cummins one of those three haha just guessing
Bandsaw
How cold was it that day? Those are some strong batteries!!
Dull axe No strength in your swing
Seems like an angle grinder would be much faster.
Wasting electric rod and wasting time
Porta band
I see a starter in your future
Where is 1 cold blooded 7.3 with bad glow plugs I'll tell you that
nice video
Wtf are you doing my brother hits harder
I have replaced them but the relay is still bad
was it actually the glow plugs bad?
My guess would be a relay
Mine does the exact same thing and the ford dealer told us the glow plugs were fine
ezgoin11 you need to look at the relay it will go bad
I've checked it and it's got power to the wiring harness but haven't pulled the valve covers and check if it has power to the plugs.
I has been doing the same I'm going to replace today
You strength for nothing: p your ax must be sharpened...
my truck do same think no start need glow plugs
Haralabos Lukatos check your relay
i not drive my truck now is few months ago happens. The engine start but when i press the gas pedal the engine cut off.
Haralabos Lukatos check the fuel filter fuse
where is locate that fuse. i switch tanks but do the same think cut the engine off.
Haralabos Lukatos it's the fuses under the hood
Bad glow plugs
Put the log on a solid surface like the ground for better cutting. The stand you are using is for holding a log while using a saw I do believe.
that probably would have helped
has bad glow plugs
that took forever!!!!
your going to need more heat... and more flux
yes your right, so I will try again after I build a new forge that can make more heat
Tough going cutting that hard old dry wood. Nice job Shane, Wranglerstar
thank Wranglerstar , It was a dead elm tree that I started cutting down with my axe and one man crosscut saw but ended up having to finish cutting it with my old chainsaw